![]() |
|
If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
Datasheet File OCR Text: |
PROGRAMMABLE DC/DC CONTROLLER FOR ADVANCED MICROPROCESSORS March 11, 1998 SC1151 TEL:805-498-2111 FAX:805-498-3804 WEB:http://www.semtech.com DESCRIPTION The SC1151 voltage mode controller contains most of the circuitry necessary to implement a DC/DC converter for powering advanced microprocessors such as Klamath, both in single and multiple processor configurations. The SC1151 features an integrated 5 bit D/A converter, pulse by pulse current limiting, integrated power good signaling, logic compatible shutdown and on-board over voltage protection (OVP). The SC1151 operates at a fixed frequency of 200kHz, providing an optimum compromise between size, efficiency and cost in the intended application areas. The integrated D/A converter provides programmability of output voltage from 2.0V to 3.5V in 100mV increments and 1.80V to 2.05V in 50mV increments with no external components. The SC1151 provides an OVP output which can be used to trigger a crowbar circuit for true over voltage protection. FEATURES * * * * 85% efficiency 5 bit DAC for output programmability On chip power good and OVP functions Designed for Intel Klamath VRM8.1 requirements APPLICATIONS * * * * Klamath microprocessor supplies Klamath VRM modules 1.8V to 3.5V microprocessor supplies Programmable power supplies ORDERING INFORMATION DEVICE (1) PACKAGE SO-16 TEMP RANGE (TJ) 0 to 125C SC1151CS Note: (1) Add suffix `TR' for tape and reel. BLOCK DIAGRAM VCC CSm CSp SHUTDOWN ABSOLUTE MAXIMUM RATINGS Parameter Symbol VIN Maximum -0.3 to 7 1 -0.3 to 15 TA TSTG TLEAD 0 to 70 -65 to +150 300 Units V V V C C C 1.25V REF VCC 70mV CURRENT LIMIT BST + VCC to GND PGND to GND BST to GND VID4 VID3 VID2 VID1 VID0 D/A AND SHUTDOWN LOGIC DECODED SHUTDOWN SIGNAL LEVEL SHIFT AND DRIVE R OSCILLATOR S Q PGND DH VOSENSE + + + PWRGOOD + VCC + ERROR AMP OVP A17043A GND Operating Temperature Range Storage Temperature Range Lead Temperature (Soldering) 10 sec PIN CONFIGURATION GND VCC OVP PWRGOOD CSm CSp PGND DH 1 2 3 4 5 6 7 8 16 15 14 13 12 11 10 9 VID0 VID1 VID2 VID3 VID4 VOSENSE SHUTDOWN BST Pentium is a registered trademark of Intel Corporation 1 (c) 1998 SEMTECH CORP. 652 MITCHELL ROAD NEWBURY PARK CA PROGRAMMABLE DC/DC CONTROLLER FOR ADVANCED MICROPROCESSORS March 11, 1998 SC1151 ELECTRICAL CHARACTERISTICS Unless specified: VCC = 4.75V to 5.25V; GND = PGND = 0V; VOSENSE = VO; 0mV < (CSp-CSm) < 60mV; TA = 25oC PARAMETER Output Voltage(2) CONDITIONS IO = 2A in Application circuit 16935F VID MIN 43210 TYP MAX UNITS V 00101 1.782 1.800 1.818 00100 1.832 1.850 1.868 00011 1.881 1.900 1.919 00010 1.931 1.950 1.969 00001 1.980 2.000 2.020 00000 2.030 2.050 2.070 11111 1.980 2.000 2.020 11110 2.079 2.100 2.121 11101 2.178 2.200 2.222 11100 2.277 2.300 2.323 11011 2.376 2.400 2.424 11010 2.475 2.500 2.525 11001 2.574 2.600 2.626 11000 2.673 2.700 2.727 10111 2.772 2.800 2.828 10110 2.871 2.900 2.929 10101 2.970 3.000 3.030 10100 3.069 3.100 3.131 10011 3.168 3.200 3.232 10010 3.267 3.300 3.333 10001 3.366 3.400 3.434 10000 3.465 3.500 3.535 Load Regulation Line Regulation UV Lockout Current Limit Voltage Oscillator Frequency Oscillator Max Duty Cycle DH Sink/Source Current Output Voltage Tempco IO = 0.3A to 13A (1) xxxxx xxxxx xxxxx xxxxx xxxxx xxxxx 60 180 90 1 1 0.5 4.2 70 200 95 80 220 % % V mV kHz % A ppm/oC BST - DH = 4.5V, DH - PGND = 2V xxxxx xxxxx 65 NOTES: (1) Low output currents, below the continuous conduction threshold will cause an increase in output voltage beyond the load regulation limit. For Application circuit 16935F see the regulation curve on sheet 5. (2) All VID codes not specifically listed here are invalid and cause shutdown exactly as if the shutdown pin had been asserted. xxxxx refers to any valid VID code. 2 (c) 1998 SEMTECH CORP. 652 MITCHELL ROAD NEWBURY PARK CA PROGRAMMABLE DC/DC CONTROLLER FOR ADVANCED MICROPROCESSORS March 11, 1998 SC1151 PIN DESCRIPTION Pin # Pin Name GND 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 VCC OVP PWRGOOD (1) Pin Function Small Signal Analog and Digital Ground Chip Supply Voltage High Signal out if VO>setpoint + 20% Open collector logic output, high if VO within 10% of setpoint Current Sense Input (negative) Current Sense Input (positive) Power Ground High Side Driver Output Vcc for High Side Driver GND VCC OVP PWRGOOD CSm 1 2 3 4 5 6 7 8 16 15 14 13 12 11 10 9 VID0 VID1 VID2 VID3 VID4 VOSENSE SHUTDOWN BST CSm CSp PGND DH BST SHUTDOWN VOSENSE VID4 VID3 VID2 VID1 VID0 (1) (1) CSp PGND DH Logic low shuts down the converter Top end of internal feedback chain Programming Input (MSB) Programming Input Programming Input Programming Input Programming Input (LSB) (1) (1) (1) (1) NOTE: (1) All logic level inputs and outputs are open collector TTL compatible 3 (c) 1998 SEMTECH CORP. 652 MITCHELL ROAD NEWBURY PARK CA PROGRAMMABLE DC/DC CONTROLLER FOR ADVANCED MICROPROCESSORS March 11, 1998 SC1151 APPLICATION CIRCUIT Q1 5V IN BUK556 L1 4uH R1 5mOhm C6 1000uF C8 1000uF C10 1000uF VCCP + C3 1000uF C1 0.1uF + C2 1000uF C4 1000uF + R2 10k R5 10 D1 PSR16C30CT + + + + + + C5 1000uF C7 1000uF C9 1000uF C12 0.1uF 12V IN R3 2.32k R4 1.00k U1 2 OVP VID0 VID1 VID2 VID3 VID4 3 16 15 14 13 10 1 SHUTDOWN PWRGD SC1151CS VCC OVP VID0 VID1 VID2 VID3 SHUTDOWN GND CSp CSm VOSENSE PWRGOOD VID4 BST DH PGND 6 5 11 4 12 9 8 7 C11 0.1uF REF 16935F C13 0.1uF MATERIALS LIST Quantity Reference 4 9 1 1 1 1 1 1 1 1 1 Part/Description Vendor Various SANYO PHOTRON 8 Turns 16AWG on MICROMETALS T50-52D core PHILIPS IRC Various Logic level FET, 22m, 30V OAR-1 Series MV-GX or equiv. Low ESR Notes C1,C11-C13 0.1F Ceramic C2-C10 D1 L1 Q1 R1 R2 R3 R4 R5 U1 1000F/6.3V PSR16C30CT 4H BUK556 5m 10k, 5%, 1/8W 2.32k, 1%, 1/8W Various 1k, 1%, 1/8W 10, 5%, 1/8W SC1151CS Various Various SEMTECH 4 (c) 1998 SEMTECH CORP. 652 MITCHELL ROAD NEWBURY PARK CA PROGRAMMABLE DC/DC CONTROLLER FOR ADVANCED MICROPROCESSORS March 11, 1998 SC1151 CHARACTERISTIC CURVES SC1151 Efficiency in Application circuit 16935F 100.0% Application circuit 16935F Ripple, 3.1V, 10A out 95.0% 90.0% 3.50V Set Efficiency 3.00V Set 85.0% 2.40V Set 80.0% 2.00V Set 75.0% 70.0% 0.0 2.0 4.0 6.0 8.0 10.0 12.0 14.0 Output Current (Amps) Application circuit 16935F Transient Response, 3.1V, 0.3A to 10A SC1151 Regulation in Application circuit 16935F 0.050 Vo at Io=300mA steady state Voltage change (V) normalized at Io=2A 0.040 0.030 0.020 0.010 0.000 Vo at Io=10A steady state -0.010 Steady state voltage levels are superimposed for reference. -0.020 0.0 2.0 4.0 6.0 8.0 10.0 12.0 14.0 Output Current (Amps) 5 (c) 1998 SEMTECH CORP. 652 MITCHELL ROAD NEWBURY PARK CA PROGRAMMABLE DC/DC CONTROLLER FOR ADVANCED MICROPROCESSORS March 11, 1998 SC1151 OUTLINE DRAWING SO-16 LAND PATTERN SO-16 6 (c) 1998 SEMTECH CORP. 652 MITCHELL ROAD NEWBURY PARK CA |
Price & Availability of SC1151
![]() |
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
[Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |