Part Number Hot Search : 
2N489 CY7C4 LM224D NTE187 M1MA151A C32R4MN 1028DI TC58F
Product Description
Full Text Search
 

To Download UTC34119 Datasheet File

  If you can't view the Datasheet, Please click here to try to view without PDF Reader .  
 
 


  Datasheet File OCR Text:
 UTC34119
DESCRIPTION
LI NEAR I NTEGRATED CI RCUI T
LOW POWER AUDIO AMPLIFIER
The UTC34119 is a low power audio amplifier integrated circuit intended (primarily) for the telephone applications, such as in speakerphones. It provides differential speaker outputs to maximize output swing at low supply voltages. Coupling Capacitor to the speaker are not required. Open loop gain is 80dB, and the closed loop gain is set with two external resistors. A chips Disable pin permits powering down and/or muting the input signal.
FEATURES
*Wide operating supply voltage: Vcc=2~16V *Low quiescent supply current(Icc=2.7mA,typical) *Medium output power Po=250mW at Vcc=6V,RL=32ohm ,Thd=10% *Load Impedance range(8 ohms to 100 ohm) *Low distortion *Mute function(Icc=65A, typical) *Minimum number of external parts required.
DIP-8
BLOCK DIAGRAM
Inverting Input NonInverting Input
4 3
Amp 1 R R
5
Output 1
Amp 2
8 1
Output 2
Vcc
6
Bias
MUTE
2
Ripplie Rejection
7
GND
YOUW ANG ELECTRONI CO. CS LTD
1
UTC34119
Characteristic
Supply Voltage Output Current Maximum input ,ripple rejection, Mute pin voltage Applied output voltage(output pin when disabled) Junction Temperature
LI NEAR I NTEGRATED CI RCUI T
Symbol
Vcc Io Vi(max) Vo Tj
ABSOLUTE MAXIMUM RATINGS(Ta=25C)
Value
-1.0~+18 250 -1.0~Vcc+1.0 -1.0~Vcc+1.0 -55 ~ +150
Unit
V mA V V C
PIN DESCRIPTION
Pin No.
1
Symbol
Mute
Description
This pin can be used to power down the IC to converse power, or for muting, or both. When at a logic "LOW"(less than 0.8V), the IC is enabled for normal operation. When at a logic "HIGH"(2.0V ~Vcc), the IC is disabled. If Mute is open, that is equivalent to a logic "LOW". A capacitor at this pin increase power supply rejection, and affects turn-on time. This pin can be left open if the capacitor at pin 1 is sufficient. Analog Ground for the amplifiers. A 1.0F capacitor at this pin (with a 5.0F capacitor at pin 8) provides 52dB(typical) of power supply rejection. Turn-on time of the circuit is affected by the capacitor on this pin. This pin can be used as an alternative input. Amplifier input. The input capacitor and resistor set low frequency roll-off and input impedance. The feedback resistor is connected between this pin and output 1. Amplifier a's output. The DC level is about (Vcc-0.7V)/2. DC supply voltage is applied to this pin(Vcc=2.0V ~16.0V) Ground pin Amplifier 2's output. This signal is equal in amplitude, but 180 out of phase with that t output 1 the DC level is about(Vcc-0.7V)/2.
2 3
Ripple Rejection Input(+)
4 5 6 7 8
input(-) Output 1 Vcc GND Output 2
RECOMMENDED OPERATION CONDITIONS(Ta=25C)
Characteristics
Supply Voltage Load Impedance Peak Load Current Differential Gain(5kHz Bandwidth) Voltage at Mute Ambient temperature
Symbol
Vcc ZL IL(peak) GV Vi(mute) Ta
Min
2.0 8 0 0 -20
Typ
Max
16 100 200 46 Vcc 470
Unit
V mA dB V C
YOUW ANG ELECTRONI CO. CS LTD
2
UTC34119
ELECTRICAL CHARACTERISTICS
(Ta=25C,Vcc=6V,unless otherwise specified)
LI NEAR I NTEGRATED CI RCUI T
Symbol Test Conditions
Vcc=3.0V, Mute=0.8V Vcc=16.0, Mute=0.8V Vcc=3.0V,Mute=2.0V RL=16 R1=75k Vcc=3.0V Vcc=6.0V Vcc=12.0V Vcc=6.0V,Rf=75k,RL=32 2.0VCharacteristic
DC Characteristics Operating current
Min
Typ
2.7 3.3 65
Max
4.0 5.0 100 1.25
Units
mA mA A V
Icc
Output Voltage
Vo
1.0
Output Offset Voltage Output High Level Output Low Level Input Bias Current Equivalent Resistance AC Characteristics Open Loop Gain of Amp 1 Open Loop Gain of Amp 2 Output Power
Voo VOH VOL Ibias REQ
-30
100 18 80 -0.35 55 250 400
1.15 2.65 5.65 0 Vcc-1.0 0.16 -100 150 25
+30
-200 220 40
mV V V nA k
Gv1 Gv2 Po
Total Harmonic Distortion (f=1.0kHz) Gain Bandwidth Product Power Supply rejection (Vcc=6.0V,Vcc=3.0V) Muting
THD GBW
f=1.0kHz,RL=32 Vcc=3.0V,RL=6,THD<10% Vcc=6.0V,RL=32,THD<10% Vcc=12.0V,RL=100,THD<10% Vcc=6.0V,RL=32,Po=125mW Vcc<3.0V,RL=8,Po=20mW Vcc<12V,RL=32,Po=200mW
0
0.35
dB dB mW
0.5 0.5 0.6 1.5 50 12 52 70
1.0 % MHz dB dB
C1=,C2=0.01F PSRR C1=0.1F,C2=0,f=1kHz, C1=1.0F,C2=5.0F,f=1kHz Gv(mute) Mute=2.0V,1.0kHzTYPICAL APPLICATION CIRCUIT
Vcc
Rf
Mute
75k
Vcc
Mute
6
0.1F R1
1
0.1F
6
Speaker
1
Speaker
4
Audio Input
5
3
Audio Input
5
UTC34119
3 2
1F 5F
UTC34119
4
3k
8 7
8 2 7
0.1F 5F
YOUW ANG ELECTRONI CO. CS LTD
3
UTC34119
Vcc
75k
LI NEAR I NTEGRATED CI RCUI T
Mute
0.001F
Vcc
Mute
0.01F
100k 100k
6
0.1F
1
0.1F
6
Speaker
1
Speaker
3
Audio Input
5
3
Audio Input
5
UTC34119
4
0.05F
UTC34119
4
0.05F
8 2 7
8 2 7
0.05F 5.1k 5.1k 5F 5.1k
0.05F 5F 5.1k
Vcc Vcc
75k
Audio Input
0.1F
3k
4
5
Speaker
4.7k
6
1
UTC34119
3 2
Vee -1.0V ~ -8.0V
Mute
20k
8
20k 10k
7
YOUW ANG ELECTRONI CO. CS LTD
4


▲Up To Search▲   

 
Price & Availability of UTC34119

All Rights Reserved © IC-ON-LINE 2003 - 2022  

[Add Bookmark] [Contact Us] [Link exchange] [Privacy policy]
Mirror Sites :  [www.datasheet.hk]   [www.maxim4u.com]  [www.ic-on-line.cn] [www.ic-on-line.com] [www.ic-on-line.net] [www.alldatasheet.com.cn] [www.gdcy.com]  [www.gdcy.net]


 . . . . .
  We use cookies to deliver the best possible web experience and assist with our advertising efforts. By continuing to use this site, you consent to the use of cookies. For more information on cookies, please take a look at our Privacy Policy. X