 |
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
| Datasheet File OCR Text: |
| PM150DSA120 Powerex, Inc., 200 Hillis Street, Youngwood, Pennsylvania 15697-1800 (724) 925-7272 IntellimodTM Module Single Phase IGBT Inverter Output 150 Amperes/1200 Volts A B G G J N T - DIA. (2 TYP.) 12345 N SIDE 1. VN1 2. SNR 3. CN1 4. VNC 5. FNO P SIDE 1. VP1 2. SPR 3. CP1 4. VPC 5. FPO N C2E1 E2 C1 S (8 TYP.) H D C 123 45 P Q - DIA. (2 TYP.) M R - THD. (3 TYP.) 0.64 MM SQ. PIN (10 TYP.) K E F P L VP1 C1 VCC FPO SPR CP1 VPC FO Description: Powerex IntellimodTM Intelligent Power Modules are isolated base modules designed for power switching applications operating at frequencies to 20kHz. Built-in control circuits provide optimum gate drive and protection for the IGBT and free wheel diode power devices. Features: Complete Output Power Circuit TEMP OUT1 SR IN GND OUT2 SENS SINK VN1 C2E1 Gate Drive Circuit Protection Logic - Short Circuit - Over Current - Over Temperature - Under Voltage Applications: Inverters UPS Motion/Servo Control Power Supplies Ordering Information: Example: Select the complete part number from the table below -i.e. PM150DSA120 is a 1200V, 150 Ampere IntellimodTM Intelligent Power Module. Type PM Current Rating Amperes 150 VCES Volts (x 10) 120 VCC FNO SNR CN1 VNC FO TEMP OUT1 SR IN GND OUT2 SENS SINK E2 Outline Drawing and Circuit Diagram Dimensions A B C D E F G H J Inches 4.33 3.660.010 2.20 2.01 Millimeters 110.0 93.00.25 56.0 51.0 Dimensions K L M N P Q R S T Inches 0.55 0.51 0.47 0.33 0.28 0.22 Dia. M5 Metric 0.100 0.08 Dia. Millimeters 14.0 13.0 12.0 8.5 7.0 Dia. 5.5 M5 2.54 Dia. 2.0 1.14 +0.04/-0.02 29.0 +1/-0.5 1.02 0.98 0.90 0.85 26.0 25.0 23.0 21.5 653 Powerex, Inc., 200 Hillis Street, Youngwood, Pennsylvania 15697-1800 (724) 925-7272 PM150DSA120 IntellimodTM Module Single Phase IGBT Inverter Output 150 Amperes/1200 Volts Absolute Maximum Ratings, Tj = 25C unless otherwise specified Characteristics Power Device Junction Temperature Storage Temperature Case Operating Temperature Mounting Torque, M5 Mounting Screws Mounting Torque, M5 Main Terminal Screws Module Weight (Typical) Supply Voltage Protected by OC and SC (VD = 13.5 - 16.5V, Inverter Part) Isolation Voltage, AC 1 minute, 60Hz Sinusoidal Symbol Tj Tstg TC -- -- -- VCC(prot.) VRMS PM150DSA120 -20 to 150 -40 to 125 -20 to 100 17 17 430 800 2500 Units C C C in-lb in-lb Grams Volts Volts Control Sector Supply Voltage Applied between (VP1-VPC, VN1-VNC) Input Voltage Applied between (CP1-VPC, CN1-VNC) Fault Output Supply Voltage (Applied between Fpo-Vpc and Fno-Vnc) Fault Output Current VD VCIN VFO IFO 20 20 20 20 Volts Volts Volts mA IGBT Inverter Sector Collector-Emitter Voltage (VD = 15V, VCIN = 5V) Collector Current, Peak Collector Current, Supply Voltage (Applied between C1 - E2) Supply Voltage, Surge (Applied between C1 - E2) Collector Dissipation VCES IC ICP VCC VCC(surge) PC 1200 150 300 900 1000 960 Volts Amperes Amperes Volts Volts Watts 654 Powerex, Inc., 200 Hillis Street, Youngwood, Pennsylvania 15697-1800 (724) 925-7272 PM150DSA120 IntellimodTM Module Single Phase IGBT Inverter Output 150 Amperes/1200 Volts Electrical and Mechanical Characteristics, Tj = 25C unless otherwise specified Characteristics Symbol Test Conditions Min. Typ. Max. Units Control Sector Over Current Trip Level Inverter Part Short Circuit Trip Level Inverter Part Over Current Delay Time Over Temperature Protection OC SC toff(OC) OT OTR Supply Circuit Under Voltage Protection UV UVR Supply Voltage Circuit Current VD ID VCIN(on) VCIN(off) fPWM IFO(H) IFO(L) Minimum Fault Output Pulse Width SXR Terminal Output Voltage tFO VSXR -20C T 125C -20C T 125C VD = 15V Trip Level Reset Level Trip Level Reset Level Applied between VP1-VPC, VN1-VNC VD = 15V, VCIN = 5V, VN1-VNC VD = 15V, VCIN = 5V, VXP1-VXPC Input ON Threshold Voltage Input OFF Threshold Voltage PWM Input Frequency Fault Output Current Applied between CP1-VPC, CN1-VNC 3Sinusoidal VD = 15V, VFO = 15V VD = 15V, VFO = 15V VD = 15V Tj 125C, Rin = 6.8 k (SPR, SNR) 200 280 -- 100 85 11.5 -- 13.5 -- -- 1.2 1.7 -- -- -- 1.0 4.5 320 450 5 110 95 12.0 12.5 15 19 19 1.5 2.0 15 -- 10 1.8 5.1 -- -- -- 120 105 12.5 -- 16.5 26 26 1.8 2.3 20 0.01 15 -- 5.6 Amperes Amperes S C C Volts Volts Volts mA mA Volts Volts kHz mA mA mS Volts 655 Powerex, Inc., 200 Hillis Street, Youngwood, Pennsylvania 15697-1800 (724) 925-7272 PM150DSA120 IntellimodTM Module Single Phase IGBT Inverter Output 150 Amperes/1200 Volts Electrical and Mechanical Characteristics, Tj = 25C unless otherwise specified Characteristics Symbol Test Conditions Min. Typ. Max. Units IGBT Inverter Sector Collector Cutoff Current ICEX VFM VCE(sat) VCE = VCEX, Tj = 25C VCE = VCEX, Tj = 125C Diode Forward Voltage Collector-Emitter Saturation Voltage -IC = 150A, VD = 15V, VCIN = 5V VD = 15V, VCIN = 0V, IC = 150A VD = 15V, VCIN = 0V, IC = 150A, Tj = 125C Inductive Load Switching Times ton trr tC(on) toff tC(off) VD = 15V, VCIN = 0 ~ 5V VCC = 600V, IC = 150A Tj = 125C 0.5 -- -- -- -- 1.4 0.2 0.4 2.5 0.6 2.5 0.4 1.0 3.5 1.1 S S S S S -- -- -- -- -- -- -- 2.5 2.3 2.1 1 10 3.5 3.2 2.9 mA mA Volts Volts Volts Thermal Characteristics Characteristic Junction to Case Thermal Resistance Symbol Rth(j-c)Q Rth(j-c)D Contact Thermal Resistance Rth(c-f) Condition Each IGBT Each FWDi Case to Fin Per Module Thermal Grease Applied Min. -- -- -- Typ. -- -- -- Max. 0.13 0.25 0.048 Units C/Watt C/Watt C/Watt Recommended Conditions for Use Characteristic Supply Voltage Symbol VCC VD Input ON Voltage Input OFF Voltage PWM Input Frequency Minimum Dead Time VCIN(on) VCIN(off) fPWM tDEAD Condition Applied across C1-E2 Terminals Applied between VP1-VPC, VN1-VNC Applied between CP1-VPC, CN1-VNC Using Application Circuit Input Signal Value 0 ~ 800 15 1.5 0 ~ 0.8 Units Volts Volts Volts 4.0 ~ VSXR Volts 5 ~ 20 3.5 kHz S 656 Powerex, Inc., 200 Hillis Street, Youngwood, Pennsylvania 15697-1800 (724) 925-7272 PM150DSA120 IntellimodTM Module Single Phase IGBT Inverter Output 150 Amperes/1200 Volts SATURATION VOLTAGE CHARACTERISTICS (TYPICAL) COLLECTOR-EMITTER SATURATION VOLTAGE CHARACTERISTICS (TYPICAL) OUTPUT CHARACTERISTICS (TYPICAL) 5 COLLECTOR-EMITTER SATURATION VOLTAGE VCE(sat), (VOLTS) SATURATION VOLTAGE VCE(sat), (VOLTS) 6 COLLECTOR CURRENT, IC, (AMPERES) 240 IC = 150A Tj = 25oC Tj = 125oC 4 VD = 15V Tj = 25oC Tj = 125oC 15 13 VD = 17V 5 4 3 2 1 0 200 160 120 80 40 3 2 1 Tj = 25oC 0 0 40 80 120 160 200 240 COLLECTOR CURRENT, IC, (AMPERES) 0 0 12 14 16 18 20 0 1 2 3 4 5 SUPPLY VOLTAGE, VD, (VOLTS) COLLECTOR-EMITTER VOLTAGE, VCE, (VOLTS) SWITCHING TIME VS. COLLECTOR CURRENT (TYPICAL) SWITCHING TIME VS. COLLECTOR CURRENT (TYPICAL) REVERSE RECOVERY CURRENT VS. COLLECTOR CURRENT (TYPICAL) 101 101 VCC = 600V VD = 15V Tj = 25oC Tj = 125oC 100 REVERSE RECOVERY TIME, trr, (S) 103 REVERSE RECOVERY CURRENT, Irr, (AMPERES) toff ton SWITCHING TIMES, tc(on), tc(off), (s) SWITCHING TIMES, ton, toff, (s) trr 100 100 tc(off) tc(on) 10-1 Irr VCC = 600V VD = 15V Tj = 25oC Tj = 125oC 102 VCC = 600V VD = 15V Tj = 25oC Tj = 125oC 10-1 101 102 COLLECTOR CURRENT, IC, (AMPERES) 103 10-1 101 102 COLLECTOR CURRENT, IC, (AMPERES) 103 10-2 101 102 EMITTER CURRENT, IE, (AMPERES) 101 103 DIODE FORWARD CHARACTERISTICS OVER CURRENT TRIP LEVEL VS. SUPPLY VOLTAGE (TYPICAL) OVER CURRENT TRIP LEVEL VS. TEMPERATURE (TYPICAL) 103 DIODE FORWARD CURRENT, IF, (AMPERES) 120 OVER CURRENT TRIP LEVEL % (NORMALIZED) OVER CURRENT TRIP LEVEL % (NORMALIZED) 140 Tj = 25oC Tj = 125oC 100 120 102 80 100 60 80 101 40 TC = 25 C o 60 VD = 15V 100 0 0.5 1.0 1.5 2.0 2.5 3.0 3.5 DIODE FORWARD VOLTAGE, VF, (VOLTS) 0 0 12 14 16 18 20 SUPPLY VOLTAGE, VD, (VOLTS) 0 0 40 80 120 160 JUNCTION TEMPERATURE, TC, (oC) 657 Powerex, Inc., 200 Hillis Street, Youngwood, Pennsylvania 15697-1800 (724) 925-7272 PM150DSA120 IntellimodTM Module Single Phase IGBT Inverter Output 150 Amperes/1200 Volts CONTROL SUPPLY VOLTAGE TRIP-RESET LEVEL TEMPERATURE DEPENDENCY (TYPICAL) TRANSIENT THERMAL IMPEDANCE CHARACTERISTICS (IGBT) TRANSIENT IMPEDANCE, Zth(j-c), (NORMALIZED VALUE) FAULT OUTPUT PULSE WIDTH VS. TEMPERATURE (TYPICAL) 120 FAULT OUTPUT PULSE WIDTH % (NORMALIZED) 14 UVr UV 101 100 UV TRIP-RESET LEVEL, UV, UVr, (VOLTS) 13 100 80 12 10-1 60 11 40 VD = 15V 10 10-2 SINGLE PULSE STANDARD VALUE = Rth(j-c)Q = 0.13oC/W 0 0 40 80 120 o 160 0 0 40 80 120 o 160 10-3 10-3 10-2 10-1 TIME, (s) 100 101 JUNCTION TEMPERATURE, TC, ( C) JUNCTION TEMPERATURE, TC, ( C) TRANSIENT THERMAL IMPEDANCE CHARACTERISTICS (FWDi) TRANSIENT IMPEDANCE, Zth(j-c), (NORMALIZED VALUE) 101 100 10-1 10-2 SINGLE PULSE STANDARD VALUE = Rth(j-c)D = 0.25oC/W 10-3 10-3 10-2 10-1 TIME, (s) 100 101 658 |
Price & Availability of PM150DSA12
 |
|
|
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
| [Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
|
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |