|
If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
Datasheet File OCR Text: |
P A ASP TruBass Audio Enhancement Processor AP8111 PRELIMINARY 1 Overview The AP8111 is a bass enhancement processor based on SRS Labs, Inc.'s patented TruBass technology. TruBass is a revolutionary psychoacoustic bass enhancement technology that provides deep, rich bass to small speakers without the need for a subwoofer or additional extra physical components. Deep bass now becomes possible even through speakers with limitations in driver and cabinet design. TruBass circuitry actively monitors the low-frequency content of an audio signal and optimizes the frequency and amplitude spectrum of the output signal to enhance bass perception. For systems with a subwoofer, TruBass complements and enhances bass performance. TruBass is therefore most suitable for applications that use small size speakers yet need to deliver the best audio quality or home theatre effect: Mini or Micro Stereo Sound Systems, TV, CD, Boombox, Car Audio, DVD Receiver, Set-Top-Box, and other compact hi-fi systems such as Discman, MD, MP3 player, as well as PCs. 2 Features Operating Voltage 4.75V to 5.25V Low Operation Current 10mA typ Power down and Bypass mode selection Analog switch for mode and gain control External adjustment for speaker size setting (small, medium and large) Bipolar Technology Chip Package 28 pins SOP The TruBass technology rights in the AP8111 are owned by SRS Labs, a United States. Corporation and licensed to ASP Microelectronics Ltd. TruBass is protected under US and foreign patents issues and/or pending. TruBass and the symbol are trademarks of SRS Labs, Inc. in the United State and selected foreign countries. Neither the purchase of the AP8111, nor the corresponding sale of audio enhancement equipment conveys the right to sell commercialized recordings made with any SRS technology. SRS Labs requires all set makers to comply with all rules and regulations as outlined in the SRS Trademark Usage Manual separately provided. For further information, please contact: SRS Labs, Inc. 2909 Daimler Street, Santa Ana, CA 92705 USA Tel: 949-442-1070 Fax: 949-852-1099 http://www.srslabs.com ASP Microelectronics Ltd. Unit 218, 2/F., Tech Centre, 72 Tat Chee Ave., Kowloon Tong, Hong Kong Tel:(852) 2797 3288 Fax: (852) 2797 3112 http://www.asp.com.hk Revision 2.4 1 [CAUTION] The information in this publication is believed to be accurate in all respects at the time of publication but is subject to change without notice. ASP Microelectronics Ltd. assumes no responsibility for errors and omissions, and disclaims responsibility for any consequences resulting from the use of information included herein. Additionally, ASP Microelectronics Ltd. assumes no responsibility for the functioning of undocumented features or parameters. 15 April., 2002 P A ASP Pin # 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 Pin Name LOUT LIN VREF NC CB1A CB1B CB1 GND TBGAIN CB2B CB2A CB2 BYPASS COMPI CL1 FOUT COMPC2 NC VCC COMPC1 CB3B CB3A CB3 CL2B NC CL2A RIN ROUT - analog output pin - analog input pin - analog bi-directional pin - digital input pin - power pin Type AOUT AIN AOUT AI/O AI/O AI/O PWR DIN AI/O AI/O AI/O DIN AIN AI/O AOUT AI/O PWR AI/O AI/O AI/O AI/O AI/O AI/O AIN AOUT Descriptions Left channel audio line output Left channel audio line input 2.25V analog reference Not used 100Hz band-pass filter circuit 100Hz band-pass filter circuit 100Hz band-pass filter circuit Analog ground TruBass gain control. +6dB gain when this pin short to ground. 40/150Hz band-pass filter circuit 40/150Hz band-pass filter circuit 40/150Hz band-pass filter circuit Power down/ Bypass / TruBass-enable selection Compressor input Low-pass filter capacitor Filter output Compressor capacitor Not used. 5 volts power supply Compressor output 60/200Hz band-pass filter circuit 60/200Hz band-pass filter circuit 60/200Hz band-pass filter circuit Low-pass filter capacitor Not used Low-pass filter capacitor Right channel audio line input Right channel audio line output AP8111 3 Device Pin Out and Pin Descriptions AOUT AIN AI/O DIN PWR Revision 2.4 2 15 April., 2002 P A ASP AP8111 4 Pin Configuration 1 2 3 4 5 6 7 8 9 10 11 12 13 14 LOUT LIN VREF NC CB1A CB1B ROUT RIN CL2A NC CL2B CB3 28 27 26 25 24 23 22 21 20 19 18 17 16 15 1 CB1 GND CB3A CB3B TBGAIN COM PC1 CB2B CB2A CB2 BYPASS COM PI VCC NC COM PC2 FOUT CL1 5 Operating Modes The chip can be configured in 3 modes of operations - Power down mode, bypass mode, TruBass mode. In power down mode, the chip is power down and consumed minimal current. In bypass mode, line in audio signal is pass directly to the output. In TruBass mode, line in audio signal is enhanced with the TruBass algorithm. The Bypass pin (pin 11) is used to select the operating mode. When the pin is forced to 0v, the chip is powered down and when the pin is at float (or Vcc/2) and at 5v, the mode is set to Bypass and TruBass Enabled respectively. An additional +6dB gain is enabled by pulling the pin TBGAIN to ground. 6 Speaker Size and Filter Center Frequencies selection The configuration of the TruBass band-pass filters depends on the speaker size for the system. There are three configurations: small, medium and large. Each configuration uses three bandpass filters, but with different center frequencies for the filters as follows: Speaker Size Small Medium Large Filter Center Frequencies 100Hz 60Hz 40Hz The low pass filter cutoff frequency and the band pass filter center frequencies can be adjusted to match the frequency response of the speakers being used. Generally, the speaker size setting should be selected so that the lowest of the band pass center frequencies is just above the low cutoff frequency of the speaker system. All configurations require the 100Hz filter, so its center frequency is fixed. The center frequencies of the other two filters are configured by the external resistors placed on pins CB2, CB2A, CB2B, CB3, CB3A, CB3B. Revision 2.4 3 15 April., 2002 P A ASP AP8111 ROUT LOUT RIN C4 4.7U LIN C1 4.7U 7 Application circuit C2 4.7U C3 4.7U 1 2 10U C5 3 4 R1 C7 0.1U 31.6K C6 0.1U R2 4.53K R3 5 6 7 8 JP2 1 2 J1 1-2 +6dB open 0dB R7 56.2K R5 21K VCC 158K R4 jumper set for gain control 8 6 4 2 C8 0.1U J3 57.6K 7 5 3 1 0.1U C9 9 10 11 12 13 R8 13K 14 AP8111 LOUT LIN VREF NC CB1A CB1B CB1 GND TBGAIN CB2B CB2A CB2 BYPASS COMPI U1 ROUT RIN CL2A NC CL2B CB3 CB3A CB3B COMPC1 VCC NC COMPC2 FOUT CL1 28 27 26 25 24 23 22 R16 21 20 19 18 17 16 15 33K R10 10U C15 10U C16 8.87K 2.32K R19 C18 0.1U R21 37.4K R20 22.1K R18 7 5 3 1 33K 0.01U C17 R15 107K 45.3K 8 6 4 2 0.1U C19 J4 63.4K R17 R9 Speaker Setting Small J3 J4 1-2, 5-6 1-2, 5-6 1-2, 5-6 3-4, 7-8 3-4, 7-8 3-4, 7-8 R6 3.09K Medium J3 J4 Large J3 J4 JP3 jumper set for operating mode 1-2 open 2-3 TruBass Bypass Power Down 10K R12 300K R22 C10 4.7U 10U C14 R13 4.7U C11 10K 100K R11 R14 37.5K C13 3300P J2 0.01U C12 1 2 3 PUNCH CONTROL 10K variable resistor Tolerance all resistors are 1%, capacitors are 10% Revision 2.4 4 15 April., 2002 P A ASP AP8111 8 Recommended Operating Condition The following is the recommended operating conditions for the TruBass analog processor Symbol VCC Vi Vo Tamb Parameter DC supply voltage DC input voltage range DC output voltage range Operating ambient temperature range Min 4.75 -0.3 0 0 Max 5.25 VCC+0.3 VCC 70 Unit Volts Volts Volts C 9 DC Electrical Specifications Symbol Vcc Icc Ipd Rin Vref Rload Cload Vil Vmid Vih Ileak Parameter Chip supply voltage Operating current Power down supply current Left/Right input impedance Analog reference voltage Resistance load at Left/Right output Capacitance load at Left/Right output Digital input logic low Mid-level for Tri-level logic Digital input logic high Digital input leakage ( except TBGAIN ) Conditions Vcc = 5.0 Vcc = 5.0 10 2.02 10 Min 4.75 Typ 5 10 25 2.25 Max 5.25 50 2.48 50 If floated, internal reference will ensure Vmid Vcc = 5.0 Vcc/2 - 10% Vcc - 0.3 -10 Vcc/2 0.3 Vcc/2 + 10% 10 Units V mA uA k V k pF V V V uA 10 AC Electrical Specifications Symbol Freq Vrli Vrlo Gerror SNR THD Xtalk Comp Rate Parameter Audio signal operating frequency Audio input signal level (0dB level reference) Audio output level Output gain error Conditions Inputs AC coupled -0.5 80 1 -70 2:1 10:1 Min 20 Typ Max 20000 1 1 0.5 Units Hz Vrms Vrms dB dB % dB Rload = 10k Bypass mode, input signal @ 0dB 1kHz Signal to noise ratio Bypass mode /Aweighted, input signal @ -60dB 1kHz Total harmonic distortion Bypass mode Input @ 0dB 1kHz Channel Crosstalk Bypass mode TruBass Compressor Ratio Punch at maximum gain Attack to decay time constant ratio Absolute value set by external capacitor Revision 2.4 5 15 April., 2002 |
Price & Availability of AP8111 |
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
[Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |