Part Number Hot Search : 
SD10195 CZMK20V KDR41208 TDA6190T AT54A ISL976 EGP08A
Product Description
Full Text Search
 

To Download MD54-0004TR Datasheet File

  If you can't view the Datasheet, Please click here to try to view without PDF Reader .  
 
 


  Datasheet File OCR Text:
 MMIC Medium Level Mixer 800 - 1000 MHz
Features
q q q q q
MD54-0004
V2.00
SO-8
PIN 8 .1497-.1574 (3.80-4.00) -B.2284-.2440 (5.80-6.20) .010(0.25) M B M
Low Conversion Loss +21 dBm 1 dB Compression LO Drive Level: +11 to +23 dBm DC - 100 MHz IF Bandwidth Low Cost Plastic SOIC Package
Orientation mark PIN 1 .1890-.1968 (4.80-5.00) -A.004 (0.10)
Description
M/A-COM's MD54-0004 is a passive mixer that achieves the performance of a double balanced diode mixer in a low cost surface mount plastic SOIC 8-lead package. The MD54-0004 is ideally suited for use where high level RF signals and very wide dynamic range are required. Typical applications include frequency up/down conversion, modulation, demodulation in systems such as cellular receivers and transmitters, and 900 MHz ISM band applications. The MD54-0004 uses FETs as mixing elements to achieve very wide dynamic range in a low cost plastic package. The mixer operates with LO drive levels of +11 dBm to +25 dBm. DC bias is not required. M/A-COM's MD54-0004 is fabricated using a mature 1-micron GaAs process. The process features full IC passivation for increased performance and reliability. *
.0532-.0688 (1.35-1.75) 0-8 -C.0040-.0098 (0.10-0.25) .013-.020 TYP. (0.33-0.51)
.0099-0.0196 x 45 Chamfer (0.25-0.50) .016-.050 (0.40-1.27) .0075-0.0098 (0.19-0.25)
.050(1.27) BSC.
.010(0.25) M C A M B S 8- Lead SOP outline dimensions Narrow body .150 (All dimensions per JEDEC No. MS-012-AA, Issue C) Dimensions in ( ) are in mm. Unless Otherwise Noted: .xxx = 0.010 (.xx = 0.25) .xx = 0.02 (.x = 0.5)
Ordering Information
Part Number MD54-0004 MD54-0004TR MD54-0004RTR MD54-0004SMB Description SOIC 8-Lead Plastic Package Forward Tape & Reel * Reverse Tape & Reel * Designer's Kit
Standard reel size is 7 inches. If other reel size is required, consult factory for part number assignment.
Electrical Specifications
Test Conditions: RF = 900 MHz (-10 dBm), LO = 840 MHz (13 dBm), IF = 60 MHz, TA = +25C Parameter Test Conditions Units Min. Conversion Loss dB Isolation LO to RF dB 25 LO to IF dB RF to IF dB VSWR LO Port RF Port IF Port Input 1 dB Compression RF Freq. = 900 MHz, LO = +13 dBm dBm Two-Tone IM Ratio1 Two tones at -10 dBm each, Tone spacing = 100 kHz, IF = 60 MHz dBc 45
1. IMR vs RF drive level can be calculated by the formula: IMR = 45 - (1.5 x PIN).
Typ. 7.5 38 22 12 2.5:1 2.0:1 2.0:1 +21 60
Max. 9.5
Specifications Subject to Change Without Notice.
M/A-COM, Inc.
North America: Tel. (800) 366-2266 Fax (800) 618-8883
s
1
Asia/Pacific: Tel. +81 (03) 3226-1671 Fax +81 (03) 3226-1451
s
Europe: Tel. +44 (1344) 869 595 Fax +44 (1344) 300 020
MMIC Medium Level Mixer
MD54-0004
V2.00
Absolute Maximum Ratings 1
Parameter RF Input Power 2 LO Drive Power 2 Operating Temperature Storage Temperature Absolute Maximum +22 dBm +23 dBm -40C to +85C -65C to +150C
Spurious Table
4x HARMONIC OF LO (n) 3x 2x 1x 0x 8.9 -1.1 2.2 -7.7 2.9 -7.1 -2.2 -12.2 X X 0x 40.1 39.9 34.2 34.1 23.7 23.8 0 0 4.7 4.8 1x 70.1 61.6 59.8 63.8 72.8 64.7 61.4 63.3 65.1 61.3 2x 69.9 63.9 67.3 64.5 72.9 63.3 71.3 61.8 71.5 61.9 3x 73.4 64.4 73 63 71.9 61.9 71.1 61.9 72.1 62.3 4x
1. Operation of this device above any one of these parameters may cause permanent damage. 2. Total power for RF and LO ports should not exceed +23 dBm.
Functional Diagram3
1 GND RF GND GND 4 5 8 GND IF LO GND
HARMONIC OF RF (m)
The spurious table shows the spurious signals resulting from the mixing of the RF and LO input signals, assuming down conversion. Mixing products are indicated by the number of dB below the conversion loss. The lower frequency mixing term is shown for two different RF input levels. The top number is for an RF input power of -5 dBm, the lower number is for -15 dBm. |mFRF - nFLO|, RF = -5 dBm |mFRF - nFLO|, RF = -15 dBm RF Frequency = 900 MHz LO Frequency = 840 MHz
3. External matching network on LO Port: R = 470 ohms, L = 18 nH, C = 4.7 pF
Typical Performance
CONVERSION LOSS VS FREQUENCY
CONVERSION LOSS (dB)
10 9 8 7 6 5 800 850 900 950 1000 50
ISOLATION vs FREQUENCY, LO = +13 dBm
LO to RF
ISOLATION (dB)
40 30
LO to IF
20
RF to IF
10 0 800 850 900 950 1000
RF FREQUENCY (MHz)
RF FREQUENCY (MHz)
INPUT P1dB (dBm)
30
RF, LO and IF VSWR vs FREQUENCY, LO = +13 dBm
IF FREQUENCY (MHz)
5 4 0 40 80 120 160 200
INPUT P1dB (dBm)
P1dB @ LO = +13 dBm
25
IF VSWR
3
20 15
LO
2
RF
1 850 900 950 1000 0 800 840 880 920 960 1000
10 800
RF FREQUENCY (MHz)
Specifications Subject to Change Without Notice.
RF and LO FREQUENCY (MHz)
2
North America: Tel. (800) 366-2266 Fax (800) 618-8883
s
M/A-COM, Inc.
Asia/Pacific: Tel. +81 (03) 3226-1671 Fax +81 (03) 3226-1451
s
Europe: Tel. +44 (1344) 869 595 Fax +44 (1344) 300 020


▲Up To Search▲   

 
Price & Availability of MD54-0004TR

All Rights Reserved © IC-ON-LINE 2003 - 2022  

[Add Bookmark] [Contact Us] [Link exchange] [Privacy policy]
Mirror Sites :  [www.datasheet.hk]   [www.maxim4u.com]  [www.ic-on-line.cn] [www.ic-on-line.com] [www.ic-on-line.net] [www.alldatasheet.com.cn] [www.gdcy.com]  [www.gdcy.net]


 . . . . .
  We use cookies to deliver the best possible web experience and assist with our advertising efforts. By continuing to use this site, you consent to the use of cookies. For more information on cookies, please take a look at our Privacy Policy. X