 |
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
| Datasheet File OCR Text: |
| C8051F330D 25 MIPS, 8 kB Flash, 10-Bit ADC, 20-Pin Mixed-Signal MCU Analog Peripherals 10-Bit ADC High-Speed 8051 C Core - - Programmable throughput up to 200 ksps Up to 16 external inputs; programmable as single-ended or differential Reference from internal VREF, VDD, or external pin Internal or external start of conversion sources Built-in temperature sensor (3 C) Pipelined instruction architecture; executes 70% of instructions in 1 or 2 system clocks Up to 25 MIPS throughput with 25 MHz clock Expanded interrupt handler 768 bytes data RAM 8 kB Flash; in-system programmable in 512 byte sectors (512 bytes are reserved) 17 port I/O; all are 5 V tolerant Hardware SMBusTM (I2CTM compatible), SPITM, and UART serial ports available concurrently Programmable 16-bit counter/timer array with three capture/compare modules, WDT 4 general-purpose 16-bit counter/timers Real-time clock mode using PCA or timer and external clock source Two internal oscillators: Memory 10-bit DAC (Current Mode) Comparator Programmable hysteresis and response time Configurable to generate interrupts or reset Low current (0.4 A) On-chip debug circuitry facilitates full speed, non-intrusive in-system debug (no emulator required) Provides breakpoints, single stepping, watchpoints Inspect/modify memory, registers, and stack Superior performance to emulation systems using ICE-chips, target pods, and sockets Typical operating current: 6.4 mA at 25 MHz 9 A at 32 kHz Typical stop mode current: <0.1 A Digital Peripherals On-Chip Debug Clock Sources Supply Voltage: 2.7 to 3.6 V -24.5 MHz, 2% accuracy supports UART operation -80 kHz low frequency, low-power External oscillator: Crystal, RC, C, or Clock (1 or 2 pin modes) Can switch between clock sources on-the-fly 20-pin DIP (lead-free package) C8051F330D-GP Temperature Range: -40 to +85 C Package Ordering Part Numbers Port 0 Latch UART Timer 0, 1, 2, 3 3-Chnl PCA/ WDT SMBus SPI Port 1 Latch P 0 D r v X B A R VDD GND Analog/Digital Power P0.0/VREF P0.1/IDAC P0.2/XTAL1 P0.3/XTAL2 P0.4/TX P0.5/RX P0.6/CNVST P0.7 P1.0 P1.1 P1.2 P1.3 P1.4 P1.5 P1.6 P1.7 C2D Debug HW RST/C2CK POR External Oscillator Circuit BrownOut Reset 8 0 5 1 8 kB FLASH 256 Byte SRAM 512 Byte XRAM P 1 D r v XTAL1 XTAL2 24.5 MHz (2%) Internal Oscillator 80kHz Internal Oscillator System Clock C o SFR Bus r e 10-bit DAC IDAC CP0 + - VREF VDD VREF Temp 10-bit 200 ksps ADC Port 2 Latch A M U X AIN0-AIN15 C2D P2.0/C2D Small Form Factor Copyright (c) 2005 by Silicon Laboratories 5.5.2005 C8051F330D 25 MIPS, 8 kB Flash, 10-Bit ADC, 20-Pin Mixed-Signal MCU Selected Electrical Specifications (TA = -40 to +85 C, VDD = 2.7 V unless otherwise specified) PARAMETER GLOBAL CHARACTERISTICS Supply Voltage Supply Current with CPU active CONDITIONS MIN 2.7 TYP 6.4 0.36 20 9 <0.1 MAX 3.6 UNITS V mA mA A A A MHz MHz kHz bits LSB LSB dB ksps V bits LSB LSB s s A s A s A s A Supply Current (shutdown) Clock Frequency Range Clock = 25 MHz Clock = 1 MHz Clock = 80 kHz; VDD Monitor Disabled Clock = 32 kHz; VDD Monitor Disabled Oscillator off; VDD Monitor Disabled DC 24.0 Note 1 25 24.5 80 10 1/2 1/2 55.5 25.0 INTERNAL OSCILLATORS Frequency (OSC0) Frequency (OSC1) A/D CONVERTER Resolution Integral Nonlinearity Differential Nonlinearity Signal-to-Noise Plus Distortion Throughput Rate Input Voltage Range Guaranteed Monotonic 53 0 10 1/2 1/2 5 0.1 7.6 0.18 3.2 0.32 1.3 1 0.4 1 1 200 VREF D/A CONVERTER Resolution Integral Nonlinearity Differential Nonlinearity Output Settling Time Guaranteed Monotonic 1 COMPARATOR Response Time Mode0 Current Consumption Mode0 Response Time Mode1 Current Consumption Mode1 Response Time Mode2 Current Consumption Mode2 Response Time Mode3 Current Consumption Mode3 (CP+) - (CP-) = 100 mV (CP+) - (CP-) = 100 mV (CP+) - (CP-) = 100 mV (CP+) - (CP-) = 100 mV Note 1: OSC1 can be calibrated in 2.5% steps using an internal calibration register. Package Information 20 C8051F330DK Development Kit MIN -- 0.015 0.115 0.014 0.014 0.045 0.030 .008 0.008 0.980 0.005 0.300 0.240 -- -- -- 0.000 0.115 INCHES TYP -- -- 0.130 0.018 0.018 0.060 0.039 0.010 0.010 1.030 -- 0.310 0.250 0.100 0.300 -- -- 0.130 MAX 0.210 -- 0.195 0.022 0.020 0.070 0.045 0.014 0.011 1.060 -- 0.325 0.280 -- -- 0.430 0.060 0.150 Top View PIN 1 IDENTIFIER E1 1 Side View D A1 A2 A D1 b3 b b2 e D1 L A A1 A2 b b1 b2 b3 c c1 D D1 E E1 e eA eB eC L Side View Pin Dimensions (Bottom View) b1 c Base Metal b c1 eA eB E 0.015" eC Small Form Factor Copyright (c) 2005 by Silicon Laboratories 5.5.2005 Silicon Laboratories and Silicon Labs are trademarks of Silicon Laboratories Inc. Other products or brandnames mentioned herein are trademarks or registered trademarks of their respective holders |
Price & Availability of C8051F330D
 |
|
|
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
| [Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
|
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |