 |
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
| Datasheet File OCR Text: |
| MODELS B, D & E 3-5/16" Diameter Multiturn Wirewound Precision Potentiometer 2 ELECTRICAL B / BSP 15 TURN D / DSP 25 TURN E / ESP 40 TURN Resistance Range, Ohms Standard Resistance Tolerance Minimum Practical Resistance Tolerance Independent Linearity Input Voltage, Maximum (Not to Exceed Power Rating) 40 to 2 Meg 5% 1% 0.50% 1,000Vdc 10 at 40C 1,000V rms 100 Megohms 5,400 +4 -0 60 to 3.3 Meg 5% 1% 0.50% 1,000Vdc 15 at 40C 1,000V rms 100 Megohms 9,000 +4 -0 125 to 5.3 Meg 5% 1% 0.50% 1,000Vdc 20 at 40C 1,000V rms 100 Megohms 14,400 +4 -0 <0.50% of Input Voltage 0.05% 0.05% 0.035% 30K >30K <150 Ohms 150 Ohms 125 Ohms to 700 Ohms 34K to 340K Power Rating, Watts (Derating to 0 at 85C) Dielectric Strength Insulation Resistance, Minimum Actual Electrical Travel, Nominal End Voltage, Maximum Minimum Practical Independent Linearity: <100 Ohms 100 Ohms to 999 Ohms 1K Ohms Noise: Tap Tolerance: 500 Ohms, Maximum, RT = 250 Ohms, Maximum, RT = 1.5, RT = 1.0, RT = Temperature Coefficient: 800ppm/C, RT = 20ppm/C, RT = 130ppm/C, RT = <0.50% of Input Voltage <0.50% of Input Voltage 0.10% 0.05% 0.035% 8K >8K <70 Ohms 70 Ohms 40 Ohms to 265 Ohms 8.6K to 128K 0.05% 0.05% 0.035% 13K >13K <100 Ohms 100 Ohms 60 Ohms to 440 Ohms 14K to 213K 300 Ohms to 8K, >142K 500 Ohms to 13.5K, >230K 800 Ohms to 30K, >340K ENVIRONMENTAL (MIL-R-12934) B / BSP 15 TURN D / DSP 25 TURN E / ESP 40 TURN Temperature Cycling, -65 to +85C Low Temperature Exposure, 24 hrs. at -65C Specifications subject to change without notice. 5% R 5% R 5% R 5% R 5% R 5% R 2-9 Model B, D & E Series MECHANICAL B / BSP 15 TURN D / DSP 25 TURN E / ESP 40 TURN Total Mechanical Travel Number of Gangs, Maximum Weight, Nominal Per Gang Static Stop Strength Backlash, Maximum Shaft End Play, Maximum Shaft Runout, T.I.R., Maximum Pilot Diameter Runout, T.I.R., Maximum Lateral Runout, T.I.R., Maximum Start/Run Torque, Maximum 5,400 +4 -0 3 13 oz. 1.150 oz.-in. 0.2 0.007" / 0.005" 0.0005" / 0.001" 0.002" / 0.0015" 0.003" / 0.0065" 2.7 / 2.0 oz.-in. 9,000 +4 -0 1 17 oz. 730 oz.-in. 0.2 0.016" / 0.007" 0.002" 0.002" 0.003" / 0.004" 3.5 / 2.5 oz.-in. 14,400 +4 -0 1 21 oz. 730 oz.-in. 0.2 0.016" / 0.007" 0.002" 0.002" 0.003" / 0.004" 3.5 / 2.5 oz.-in. SPECIAL FEATURE CODES Center Tap Linearity Tape Rear Shaft Extension Flatted Shaft Slotted Shaft ORDERING INFORMATION CT LT RS FS SS B R 10K T1 L .5 XX Model Series Resistance Prefix Resistance Value Optional Special Feature Code Linearity Optional Non-Standard Tolerance CIRCUIT DIAGRAM NOTES Metric equivalents, based on 1 inch = 25.4mm are rounded to the same number of significant figures as in the original English units and are provided for general information only. Tolerances unless otherwise specified: Linear = .01 inches (.25mm) Angular = 2 degrees (S) (CCW) (CW) INCH mm 2-10 Model B, D & E Series OUTLINE DIMENSIONS (Inch/mm) Mounting Surface 1.500.031 38.100.79 .500.016 12.70.41 CW 2.031.031 R. 51.590.79 +0.0000 .5937 -0.0020 Dia. +0.0000 15.0800 -0.0508 31 2 1.875.031 R. 47.630.79 Models B, D & E Bushing Mount with Sleeve Bearing 1.000.031 25.400.79 Slider CCW 2 3.312.016 Dia. 84.130.41 E Model B D E Dim. "L" 2.875.031 73.030.79 4.141.047 105.21.19 6.016.047 152.81.19 D "L" B +.000 .062 -.010 +0.00 1.58 -0.25 +.0000 .2497 -.0003 Dia. +0.0000 6.3424 -0.0076 Chamfer .016 Max. x 45 0.41 .531.016 13.490.41 1/2 - 32 NS Thread Locating Hole .129.005 .062.016 Dia. x Deep 3.280.13 1.580.41 Positioned as shown5 OUTLINE DIMENSIONS (Inch/mm) Models BSP, DSP & ESP Servo Mount with Ball Bearing Mounting Surface .563 Max. 14.3 Slider CCW 1.000.031 25.400.79 CW Chamfer 3.312.016 Dia. 84.130.41 2.031.031 R. 51.590.79 .016 Max. x 45 0.41 30 2 1.875.031 R. 47.630.79 ESP DSP BSP "L" +.0000 -.0003 Dia. +0.0000 6.3424 -0.0076 .2497 .093.005 2.360.13 .062.005 1.580.13 +.000 3.312 -.001 Dia. +0.00 84.13 -0.03 3.500.005 Dia. 88.9000.13 Model BSP DSP ESP Dim. "L" 2.828.031 71.830.79 4.062 Max. 103.2 5.937 150.8 Max. 2-11 Model B, D & E Series |
Price & Availability of BR10KT1L5XX
 |
|
|
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
| [Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
|
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |