View PLL602-10DM_1296533.PDF datasheet online --- IC-ON-LINE

Datasheet File OCR Text:

Preliminary
PLL602-10
96MHz - 400MHz Low Phase Noise XO (for 12 - 25MHz Crystals)
FEATURES
* * * * * * Low phase noise output for the 96MHz to 400MHz range (-134 dBc at 10kHz offset). Selectable CMOS, PECL and LVDS output. 12 to 25MHz crystal input. Output Enable selector. 3.3V operation. Available in DIE (65 mil x 62 mil).
DIE CONFIGURATION
65 mil (1550,1475)
19 18 17 16 25 26 24 23 22 21 20
27
15
28
14
62 mil
13 29 12
11 30
DESCRIPTIONS
31
10 9 1 2 3 4 5 6 7 8
The PLL602-10 is a monolithic low jitter and low phase noise (-134dBc/Hz @ 10kHz offset) XO IC Die, with CMOS, LVDS and PECL output, for 96MHz to 400MHz output range, using a low frequency crystal. The same die can be used as a XO with output frequencies ranging from F XIN x 8 to F XIN x 16 thanks to selector pads allowing bonding options (see Divider Selection Table on this page). This makes the PLL602-10 ideal for a wide range of applications.
Y X
(0,0)
MULTIPLIER SELECTION
Pad #19 MULTIPLIER OUTPUT RANGE
0 1
FXIN x 16 FXIN x 8
192 - 400 MHz 96 - 200 MHz
Note: Selector pad defaults to `1', wire bond to GND to set to `0'
DIE SPECIFICATIONS
Name Size Reverse side Pad dimensions Thickness Value 62 x 65 mil GND 80 micron x 80 micron 10 mil
OUTPUT SELECTION AND ENABLE
Pad #18 OUTSEL1 0 0 1 1 Pad #25 OUTSEL0 0 1 0 1 Selected Output High Drive CMOS Standard CMOS PECL LVDS State Tri-state Output enabled
OE (Pad #30) 0 1 (Default)
BLOCK DIAGRAM
VCO Divider
SELECT
Reference Divider
Phase Comparator
Charge Pump
Loop Filter
VCO
CLKBAR CLK
XIN XOUT
XTAL OSC
OE
47745 Fremont Blvd., Fremont, California 94538 TEL (510) 492-0990 FAX (510) 492-0991
Rev 11/06/02 Page 1
Preliminary
PLL602-10
96MHz - 400MHz Low Phase Noise XO (for 12 - 25MHz Crystals)
ELECTRICAL SPECIFICATIONS
1. Absolute Maximum Ratings PARAMETERS Supply Voltage Input Voltage, dc Output Voltage, dc Storage Temperature Ambient Operating Temperature Junction Temperature Lead Temperature (soldering, 10s) Input Static Discharge Voltage Protection SYMBOL V DD VI VO TS TA TJ V SS -0.5 V SS -0.5 -65 0 MIN. MAX. 7 V DD +0.5 V DD +0.5 150 70 125 260 2 UNITS V V V C C C C kV
Exposure of the device under conditions beyond the limits specified by Maximum Ratings for extended periods may cause permanent damage to the device and affect product reliability. These conditions represent a stress rating only, and functional operations of the device at these or any other conditions above the operational limits noted in this specification is not implied.
2. Crystal Specifications PARAMETERS Crystal Resonator Frequency Crystal Loading Rating Recommended ESR SYMBOL F XIN C L (xtal) RE AT cut CONDITIONS Parallel Fundamental Mode MIN. 12 TBD 30 TYP. MAX. 25 UNITS MHz pF
47745 Fremont Blvd., Fremont, California 94538 TEL (510) 492-0990 FAX (510) 492-0991
Rev 11/06/02 Page 2
Preliminary
PLL602-10
96MHz - 400MHz Low Phase Noise XO (for 12 - 25MHz Crystals)
3. General Electrical Specifications PARAMETERS Supply Current, Dynamic (with Loaded Outputs) Operating Voltage Output Clock Duty Cycle Short Circuit Current 4. Jitter and Phase Noise specification PARAMETERS Period jitter RMS Accumulated jitter RMS Phase Noise relative to carrier Phase Noise relative to carrier Phase Noise relative to carrier Phase Noise relative to carrier CONDITIONS With capacitive decoupling between VDD and GND. With capacitive decoupling between VDD and GND. Over 10,000 cycles. 155MHz @100Hz offset 155MHz @1kHz offset 155MHz @10kHz offset 155MHz @100kHz offset MIN. TYP. 7 11 -90 -114 -134 -134 MAX. UNITS ps ps dBc/Hz dBc/Hz dBc/Hz dBc/Hz SYMBOL I DD V DD @ 1.4V (CMOS) @ 1.25V (LVDS) @ Vdd - 1.3V (PECL) CONDITIONS PECL/LVDS/CMOS 3.13 45 45 45 MIN. TYP. MAX. 80/60/35 3.47 55 55 55 UNITS mA V % mA
50 50 50 50
47745 Fremont Blvd., Fremont, California 94538 TEL (510) 492-0990 FAX (510) 492-0991
Rev 11/06/02 Page 3
Preliminary
PLL602-10
96MHz - 400MHz Low Phase Noise XO (for 12 - 25MHz Crystals)
5. LVDS Electrical Characteristics PARAMETERS Output Differential Voltage V DD Magnitude Change Output High Voltage Output Low Voltage Offset Voltage Offset Magnitude Change Power-off Leakage Output Short Circuit Current 6. LVDS Switching Characteristics PARAMETERS Differential Clock Rise Time Differential Clock Fall Time
LVDS Levels Test Circuit
OUT
SYMBOL V OD V OD V OH V OL V OS V OS I OXD I OSD
CONDITIONS
MIN. 247 -50
TYP. 355 1.4
MAX. 454 50 1.6 1.375 25 10 -8
UNITS mV mV V V V mV uA mA
R L = 100 (see figure)
0.9 1.125 0
1.1 1.2 3 1 -5.7
V out = V DD or GND V DD = 0V
SYMBOL
tr tf
CONDITIONS R L = 100 C L = 10 pF (see figure)
MIN. 0.2 0.2
TYP. 0.7 0.7
MAX. 1.0 1.0
UNITS ns ns
LVDS Switching Test Circuit
OUT
50
CL = 10pF
VOD
VOS
VDIFF
RL = 100
50 CL = 10pF OUT OUT
LVDS Transistion Time Waveform
OUT 0V (Differential) OUT
80% V DIFF 20% 0V
80%
20%
tR
tF
47745 Fremont Blvd., Fremont, California 94538 TEL (510) 492-0990 FAX (510) 492-0991
Rev 11/06/02 Page 4
Preliminary
PLL602-10
96MHz - 400MHz Low Phase Noise XO (for 12 - 25MHz Crystals)
7. PECL Electrical Characteristics PARAMETERS Output High Voltage Output Low Voltage SYMBOL V OH V OL CONDITIONS R L = 50 to (V DD - 2V) (see figure) MIN. V DD - 1.025 V DD - 1.620 MAX. UNITS V V
8. PECL Switching Characteristics PARAMETERS Clock Rise Time Clock Fall Time SYMBOL
tr tf
CONDITIONS @20/80% - PECL @80/20% - PECL
MIN.
TYP. 0.6 0.5
MAX. 1.5 1.5
UNITS ns ns
PECL Levels Test Circuit
OUT VDD OUT
PECL Output Skew
50
2.0V 50%
50 OUT OUT tSKEW
PECL Transistion Time Waveform
DUTY CYCLE
45 - 55%
55 - 45%
OUT 80% 50% 20% OUT tR tF
47745 Fremont Blvd., Fremont, California 94538 TEL (510) 492-0990 FAX (510) 492-0991
Rev 11/06/02 Page 5
Preliminary
PLL602-10
96MHz - 400MHz Low Phase Noise XO (for 12 - 25MHz Crystals)
PAD ASSIGNMENT
Pad # 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 Name GND GND GND GND GND N/C GND GNDBUF CMOS LVDS PECL VDDBUF VDDBUF PECLB LVDSB CMOSB GNDBUF OUTSEL1 FSEL N/C VDD VDD VDD VDD OUTSEL0 XIN XOUT N/C N/C OE N/C X ( m) 248 361 473 587 702 874 1042 1171 1400 1400 1400 1400 1400 1400 1400 1400 1389 1232 1042 854 659 559 459 358 194 109 109 109 109 109 109 Y ( m) 109 109 109 109 109 109 109 109 125 259 476 616 716 871 1089 1227 1365 1365 1365 1365 1365 1365 1365 1365 1365 1223 1017 858 646 397 181
47745 Fremont Blvd., Fremont, California 94538 TEL (510) 492-0990 FAX (510) 492-0991
Rev 11/06/02 Page 6
Preliminary
PLL602-10
96MHz - 400MHz Low Phase Noise XO (for 12 - 25MHz Crystals)
ORDERING INFORMATION
For part ordering, please contact our Sales Department:
47745 Fremont Blvd., Fremont, CA 94538, USA Tel: (510) 492-0990 Fax: (510) 492-0991
The order number for this device is a combination of the following: Device number, Package type and Operating temperature range
PART NUMBER
PLL602-10 D C
PART NUMBER TEMPERATURATRE
C=COMMERCIAL M=MILITARY
I=INDUSTRAL
D=DIE
PACKAGE TYPE
PhaseLink Corporation, reserves the right to make changes in its products or specifications, or both at any time without notice. The information furnished by Phaselink is believed to be accurate and reliable. However, PhaseLink makes no guarantee or warranty concerning the accuracy of said information and shall not be responsible for any loss or damage of whatever nature resulting from the use of, or reliance upon this product. LIFE SUPPORT POLICY: PhaseLink's products are not authorized for use as critical components in life support devices or systems without the express written approval of the President of PhaseLink Corporation.
47745 Fremont Blvd., Fremont, California 94538 TEL (510) 492-0990 FAX (510) 492-0991
Rev 11/06/02 Page 7

▲Up To Search▲

Price & Availability of PLL602-10DM

	To Download PLL602-10DM Datasheet File
If you can't view the Datasheet, Please click here to try to view without PDF Reader .