![]() |
|
If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
Datasheet File OCR Text: |
FREQUENCY QEV101 SMD 7x5 VCXO - Communications Equipment Application Specification (Rev-F) Electrical Characteristics ......................................................P01 Mechanical Characteristics ...................................................P02 Ordering Information .............................................................P03 Suggested Reflow Soldering profile ......................................P03 Tape Drawing........................................................................P04 Reel Drawing ........................................................................P04 Frequency QEV101 SMD 7x5 VCXO - Communications Equipment Application Specification (rev-F) April 05th, 2006 Electrical Characteristics Electrical Parameters Frequency range Output logic Operating temperature range (see table 1) Storage temperature range Power supply voltage (VCC) 3.3V version 5.0V version Frequency Stability (see note 1) Unit MHz Minimum 1.544 Typical Maximum 65.536 Test conditions HCMOS / TTL Output C C VDC ppm ppm mA pF VDC 90%VCC 15 -55 3.135 4.750 3.3 5.0 25 or 50 3 40mA 55mA 30 With 30pF HCMOS Load Refer to Ordering Information 20 45 50 55 10 10 100 20% VCC ~ 80% VCC 0 to +70 -40 to +85 +125 3.465 5.250 Refer to Ordering Information Refer to Ordering Information Ref at 25C Refer to Ordering Information Aging (First Year) Input current 3.3V version 5.0V version HCMOS Output load Output Logic Levels Output Logic High (VOH) Output Logic Low (VOL) Pullability 3.3V VC=1.65 1.50V 5.0V VC=2.50 2.00V 10%VCC 50, 100 or 150 Positive slope ppm % % ns ms K Linearity Duty cycle Rise & Fall time Start-up time Input Impedance Note 1: Include 25C tolerance, operating temperature range, input voltage change (VCC5%), load change (15pF10%), first year aging, shock and vibration. Table 1 : Stability Codes 25ppm 50ppm 0 to +70C C A - 40 to +85C D B Table 2 : Phase Noise Unit 10Hz 100Hz 1KHz 10KHz Floor Maximum values for 20MHz VCXO dBc/Hz - 60 - 90 -120 -135 -145 1 TEMEX reserves the right to modify herein specifications and informations at any time when necessary to provide optimum performance and cost. Frequency QEV101 SMD 7x5 VCXO - Communications Equipment Application Specification (rev-F) April 05th, 2006 Mechanical Characteristics BOTTOM VIEW SUGGESTED PAD Hmax = 2.0mm max #1 #2 #3 #4 #5 #6 Pin connections VCONTROL Tri state Ground Output N.C. +VCC Line 1 Line 2 Line 3 Marking Manufacturing code + V1 + stability/supply voltage/pulling code Frequency in MHz (6 digits) Date code (YYWW) Tristate Function Pin 1 Open "1" "0" Output (Pin 4) Active Active High Z Example for QEV101BAB / 10MHz Line 1 : NV1BAB Line 2 : 10.000 Line 3 : 0614 2 TEMEX reserves the right to modify herein specifications and informations at any time when necessary to provide optimum performance and cost. Frequency QEV101 SMD 7x5 VCXO - Communications Equipment Application Specification (rev-F) April 05th, 2006 Ordering Information QEV101 B Part numbering system A B 10.000MHZ Package type SMD Package QEV101 : SMD 7x5 Temperature Stability Supply Voltage A : + 5.0V D : +3.3V A: B: D: Pulling Range 100ppm min 150ppm min 50ppm min Nominal Frequency (MHz) Please enter the nominal frequency A: 50ppm vs 0 to +70C B : 50ppm vs -40 to +85C C : 25ppm vs 0 to +70C D : 50ppm vs -40 to +85C Suggested Reflow Soldering Profile 3 TEMEX reserves the right to modify herein specifications and informations at any time when necessary to provide optimum performance and cost. Frequency QEV101 SMD 7x5 VCXO - Communications Equipment Application Specification (rev-F) April 05th, 2006 Tape Drawing Item Pitch of components Pitch of sprocket hole Length from hole center to component center Width of carrier tape Width of adhesive tape Height of component hole Width of component hole Gap of hold down tape and carrier tape Diameter of sprocket hole Diameter of feed hole Total of tape thickness Code P Po P1 W W0 A B W2 Do D1 K Dimension 8.0 4.0 2.0 16.0 7.5 8.18 5.56 1.75 1.5 1.5 2.16 Tolerance 0.1 0.1 0.1 +0.3/-0.1 0.1 0.1 0.1 0.1 0.05 0.25 0.1 Reel Drawing Multiple : 1Kpcs per Reel Unit : mm 4 TEMEX reserves the right to modify herein specifications and informations at any time when necessary to provide optimum performance and cost. |
Price & Availability of QEV101
![]() |
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
[Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |