 |
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
| Datasheet File OCR Text: |
| THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 851-5040. PHONE (630) 851-4722. www.conwin.com PRODUCT D ATA SHEET CRYSTAL CONTROLLED OSCILLATORS CW 0107 ASOV3S3 12.80M SURFACE MOUNT 3.3V HCMOS STRATUM 3 OCXO ABSOLUTE MAXIMUM RATINGS PARAMETER Storage Temperature Supply Voltage Control Voltage OPERATING SPECIFICATIONS PARAMETER Center Frequency Frequency Calibration, Vc=1.48 Vdc Frequency Stability Aging (Daily) Aging (20 Years) Total Frequency Tolerance Operating Temperature Range Supply Voltage Supply Current Phase Jitter (BW=12KHz to 20MHz) Phase Jitter (BW=10Hz to 20MHz) Period Jitter SSB Phase Noise at 10Hz offset SSB Phase Noise at 10KHz offset Warm Up Time TDEV @ 1.0 Sec. TDEV @ 4.0 Sec. INTPUT CHARACTERISTICS PARAMETER Control Voltage Range Frequency at Vc=0.3 Vdc Frequency at Vc=3.0 Vdc Slope of Frequency Adjust Input Impedance HCMOS OUTPUT CHARACTERISTICS PARAMETER LOAD Voltage (High) (Low) Current (High) (Low) Duty Cycle at 50% of Vcc Rise / Fall Time 10% to 90% PACKAGE CHARACTERISTICS Package (Voh) (Vol) (Ioh) (Ioh) MINIMUM 2.6 -4 45 NOMINAL 50 MAXIMUM 15 0.4 4 55 6 UNITS pf Vdc Vdc mA mA % nS (Vc) MINIMUM 0.3 -22.5 13.5 5 100k NOMINAL 1.48 MAXIMUM 3.0 -13.5 22.5 UNITS Vdc ppm ppm ppm/V Ohm TABLE 4.0 NOTE 6 6 (Vcc) (Icc) (Fo) MINIMUM 1.544 -1.5 -0.25 -30 -2.5 -4.6 0 3.135 3.3 -90 -135 NOMINAL MAXIMUM 20.0 1.5 0.25 30 2.5 4.6 70 3.465 450 1 3 5 5 1 2 UNITS MHz ppm ppm ppb ppm ppm C Vdc mA ps rms ps rms ps rms dBc/Hz dBc/Hz Minutes nS nS 1 2 3 4 UNITS (Vcc) (Vc) MINIMUM -40 -0.5 -0.5 NOMINAL MAXIMUM 85 4.5 4.5 UNITS C Vdc Vdc TABLE 2.0 NOTE TABLE 1.0 NOTE ASOV3S3 DESCRIPTION 5 The Connor-Winfield ASOV3S3 is a true Surface Mount 3.3V Oven Controlled Crystal Oscillator (OCXO) with an HCMOS output. The ASOV3S3 is designed for Stratum 3 applications requiring tight frequency stability and low jitter. TABLE 3.0 NOTE FEATURES FREQUENCY ADJUST 3.3V OPERATION LOW JITTER <1pS RMS TEMPERATURE STABILITY 0.25ppm FREQUENCY TOLERANCE OF 4.6ppm OVER TWENTY YEARS SURFACE MOUNT PACKAGE TAPE AND REEL PACKAGING TABLE 5.0 Surface Mount, Non-hermetic package consisting of an FR4 substrate with grounded metal cover. TABLE 6.0 The component solder used internal to this device has a mel ting point of 221C. The peak temperature inside the device should be less than or equal to 220C for a maximum of 10 seconds Ultrasonic cleaning is not recommended PROCESS RECOMMENDATIONS Solder Reflow Wash ORDERING INFORMATION Notes: 1) 2) 3) 4) Initial calibration @ 25C, Vc=1.48 Vdc. Frequency vs. temperature stability, 0 to 70C absolute. At the time of shipment after48 hours of operation. Inclusive of calibration, operating temperature range, supply voltage change, load change, shock and vibration, 20 years aging, Vc=1.48 Vdc. 5) Measured @ 25C, within 5 minutes, the unit will be within +/-0.1ppm of its reference frequency, measured after 30 minutes of continuo us operation at a stable 25C 6) Referenced to Fo @ 25C, Positive Transfer Characteristic ASOV3S3 - 12.80MHz OCXO SERIES CENTER FREQUENCY Specifications subject to change without notice. DATA SHEET #: Cx019 PAGE 1 OF 2 REV: 05 DATE: 11/12/04 aCopyright 2001 Connor-Winfield all rights reserved. THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 851-5040. PHONE (630) 851-4722. www.conwin.com PRODUCT D ATA SHEET CRYSTAL CONTROLLED OSCILLATORS ENVIRONMENTAL CHARACTERISTICS Temperature Cycle: Per MIL-STD-883, Method 1010, Condition B. -55C to 125C, 20 cycles,10 minute dwell, 1m inute transition. Gross Leak Test: Per MIL-STD-202, Method 112, Condition D. No bubbles in flourinert (FC-43) at 125C 5C for 20 seconds. SOLDERING Pin Solderability: Per MIL-STD-883, Method 2003. 8 hour steam age prior to 245C 5C Solder pot dip, 95% Coverage. Resistance to Solder Heat: Per MIL-STD-202, Method 210, Condition C. Wave: Topside board -mount product, 260C 5C for 20 Seconds. MECHANICAL CHARACTERISTICS Vibration: Per MIL-STD-202, Method 204, Condition A. 10G's peak, 10Hz to 500Hz, 15minut e cycles 12 times each perpendicular axis. Shock: Per MIL-STD-202, Method 213, Condition D. 500G's, 1ms, half sine, 3 shocks per direction. Moisture Resistance: Per MIL-STD-202, Method 106. 95% RH @ 65C, 10 cycles 10C to 65C. PIN FUNCTION .330 max (8.382mm) CW DATE CODE ASOV3S3 12.80M 1 7 8 14 CONTROL VOLTAGE GROUND (CASE) OUTPUT Vcc Dimensional Tolerance: .005 (.127mm) KEEP OUT AREA 90% .830 (21.08mm) 50% 10% .565 (14.35mm) CONTROL VOLTAGE 3.0Vdc POWER SUPPLY 3.3Vdc 14 8 1 7 Specifications subject to change without notice. DATA SHEET #: Cx019 PAGE 2 OF 2 REV: 05 DATE: 11/12/04 aCopyright 2001 Connor-Winfield all rights reserved. |
Price & Availability of ASOV3S3
 |
|
|
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
| [Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
|
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |