telephone +44 (0)1229 582430 fax: +44 (0)1229 585155 email: sales@marl.co.uk website: www.marl.co.uk website: www.marl-leds.com filament replacement leds - t1 3 / 4 mlq = 20 dimensions in mm (typical) scale 1:1 leds leds 205 series direct replacement for t1 3 / 4 mg s5.7s reverse polarity options centre contact, anode as standard part number colour lens voltage current luminous wave viewing operating storage dc dc intensity length angle temp temp vopr lopr lv@20ma l p topr tstg high intensity 205-501-04-38 red 1.9* 20 2750 660 205-521-04-38 yellow 2.0* 20 4500 590 205-532-04-38 green 3.4* 20 6000 525 205-930-04-38 blue 3.4* 20 2000 470 205-997-04-38 white 3.4* 20 3000 205-501-20-38 red 5/6 16 2750 660 205-521-20-38 yellow water clear 5/6 15 4500 590 wide -40~+80 -40~+80 205-532-20-38 green 5/6 14 6000 525 205-930-20-38 blue 5/6 14 2000 470 205-997-20-38 white 5/6 14 3000 205-501-22-38 red 24 20 2750 660 205-521-22-38 yellow 24 20 4500 590 205-532-22-38 green 24 20 6000 525 205-930-22-38 blue 24 20 2000 470 205-997-22-38 white 24 20 3000 * units vdc ma mcd nm ? ? high intensity green dot on base of product signifies reverse polarity. colour dot on led denotes led colour. * = voltage dc for 20ma product is vf@20ma, not vopr ?= typical emission colour: x=0.31, y=0.32. colour temperature 8000k . intensities (iv) and colour shades of white (x,y co - ordinates) may vary between leds within a batch. please note - this product is also available at 12, 28 and 48vdc. please contact our sales department for further details. ordering information & typical technical characteristics (ta = 25?) mean time between failure = 100,000 hours. luminous intensity figures refer to the unmodified discrete led . for new products see our website section 2; fil.rep.leds for pdf 19/1/00 12:42 pm page 30
|
