catch us on the web! www.cotorelay.com e-mail us: sales@cotorelay.com 30 9200-9300 series/surface mount reed relays s s s s s urface urface urface urface urface m m m m m ount ount ount ount ount r r r r r eed eed eed eed eed r r r r r elays elays elays elays elays ideally suited to the needs of automated test equipment, instrumentation and telecommunications requirements, cotos 9200, and 9300 series specification tables allow you to select the appropriate relay for your particular application. if your requirements differ, please consult your local representative or cotos factory to discuss a custom design. s s s s s eries eries eries eries eries f f f f f eatures eatures eatures eatures eatures u high insulation resistance - 10 12 w minimum (10 13 w typical). u high reliability, hermetically sealed contacts for long life. u molded thermoset body on integral lead frame design. u high speed switching compared to electromechanical relays. 9200 ser 9200 ser 9200 ser 9200 ser 9200 ser ies ies ies ies ies u low profile - 0.19 height. meets high board density requirements. u 50 w coaxial shield for rf and fast rise time pulse switching. 9300 ser 9300 ser 9300 ser 9300 ser 9300 ser ies ies ies ies ies u load switching (15 watts) and high dielectric strength (500 vdc) between contacts. dimensions in inches (millimeters) model 9200 model 9300 gull wing gull wing axial j-lead j-lead radial axial 2 2 2 2
coto technology 55 dupont drive, providence, ri 02907-3105 / (401) 943-2686 fax (401) 942-0920 31 m o d e l n u m b e r 9 2 01 9 2 02 9 3 01 p a r a m e t e r s t e s t c on d iti o n s u n it s 1 f o r m a 1 f o r m a c o i l s p e c s . nom. coil voltage vdc 5 12 5 12 5 12 max. coil voltage vdc 6.5 15.0 6.5 15.0 6.5 15.0 coil resistance +/- 10%, 25 c w 250 650 150 650 350 1000 operate voltage must operate by vdc - max. 3.75 9.0 3.75 9.0 3.75 9.0 release voltage must release by vdc - min. 0.4 1.0 0.4 1.0 0.4 1.0 c o n t a c t r a t i n g s switching voltage max dc/peak ac resist. volts 200 200 200 switching current max dc/peak ac resist. amps 0.5 0.5 0.5 carry current max dc/peak ac resist. amps 1.5 1.5 1.5 contact rating max dc/peak ac resist. watts 10 10 15 life expectancy-typical 1 signal level 1.0v,10ma x 10 6 ops. 1000 1000 250 static contact resistance ( max. init. ) 50mv, 10ma w 0.150 0.150 0.150 dynamic contact resistance (max. init.) 0.5v, 50ma at 100 hz, 1.5 msec w 0.200 0.200 0.200 r e l a y s p e c i f i c a t i o n s insulation resistance (minimum) between all isolated pins at 100v, 25c, 40% rh w x 10 12 x 10 12 x 10 12 capacitance - typical across open contacts no shield shield floating shield guarding pf pf pf 0.7 - - - 0.8 0.1 0.7 - - open contact to coil no shield shield floating shield guarding pf pf pf 1.4 - - - 1.4 0.2 1.4 - - contact to shield contacts open, shield floating pf - 1.4 - dielectric strength (minimum) between contacts contacts to shield contacts/shield to coil vdc/peak ac vdc/peak ac vdc/peak ac 300 - 1500 300 1500 1500 x 500 3 - 1500 operate time - including bounce - typical at nominal coil voltage, 30 hz square wave msec. 0.40 0.40 0.40 release time - typical zener-diode suppression 4 msec. 0.10 0.10 0.10 1 f o r m a 5 0 w c o a x i a l 9200-9300 series/surface mount reed relays environmental ratings storage temp: - 35c to + 100c; operating temp: - 20c to + 85c the operate and release voltage and the coil resistance are specified at 25c. these values vary by approximately 0.4%/c as the ambient temperature varies. vibration: 20 gs to 2000 hz; shock: 50 gs notes: 1 consult factory for life expectancy at other switching loads. 2 surface mount component processing temperature: 430f(221c) max for 1 minute dwell time. temperature measured on leads where lead exits molded package. 3 higher dielectric strength available, consult factory. 4 consists of 20v zener-diode and 1n1002 diode in series, connected in parallel with coil. top view: dot stamped on top of relay refers to pin #1 location
|
