unisonic technologies co., ltd p2583 linear integrated circuit www.unisonic.com.tw 1 of 6 copyright ? 2011 unisonic technologies co., ltd qw-r103-052.b 380khz, 3a step-down switching regulator ? description the utc p2583 is a fixed 380khz frequency, current mode, pwm controller with an internal power mosfet. it achieves 3a continuous output current over a wide input supply range with excellent load and line regulation. equipped with an external compensation pin, this device offers user flexibility in determining loop dynamic. the utc p2583 integrates controls, monitoring and protection functions into a single 8-pin package to provide a low cost and perfect power solution. the device provides wide 3.6v to 28v operating input range, also highly efficient with peak operating efficiency at 90%. an under- voltage-lock-output (uvlo) circuit monitors the vin supply voltage to prevent wrong logic cont rols. an internal 1.222v reference provides low output voltage down to 1.22v for further applications. the controller?s over-current protection m onitors the output cu rrent by using the voltage drop across a current sensing resistor. additional under voltage protections monitor the voltage on fb pin for short-circuit protections. the utc p2583 provides fast transient respond and requires very few external devices for operation. ? features * 3a output current * v in =3.6v,v out =2.5v,i load_max up to 3a * 380khz frequency of operation * 3.6v to 28v input voltage range * 25 a shutdown supply current * output adjustable from 1.22v to 21v * frequency foldback at short circuit * thermal shutdown * under voltage lock output * current mode with low esr output ceramic capacitors * up to 90% efficiency ? ordering information ordering number lead free halogen free package packing P2583L-S08-R p2583g-s08-r sop-8 tape reel p2583l-s08-t p2583g-s08-t sop-8 tube p2583g -s08 -r (1)packing type (2)package type (1) r: tape reel, t: tube (2) s08: sop-8 (3) g: halogen free, l: lead free (3)halogen free
p2583 linear integrated circuit unisonic technologies co., ltd 2 of 6 www.unisonic.com.tw qw-r103-052.b ? pin configuration nc 1 in 2 sw 3 8 nc 7 en 6 comp 5 fb gnd 4 ? pin description pin no. pin name description 1 nc nc 2 in power supply pin. 3 sw power switch output pin. 4 gnd ground pin. 5 fb the output voltage feedback pin. it is also the inverting input of the error amplifier. 6 comp compensation pin. it is also the output of the internal error amplifier. (1). a rc network at this pin compensates the control loop. (2). the voltage at this pin controls t he peak current of the internal switch. 7 en regulator on/off control pin. leave en unconn ected if unused. a low input at en turns on the converter, and a hi gh input turns it off. 8 nc nc
p2583 linear integrated circuit unisonic technologies co., ltd 3 of 6 www.unisonic.com.tw qw-r103-052.b ? block diagram + - + - + - + s r q + reference 50k-380khz slope comp in nc 3 4gnd 2 6 1 comp 5 fb 7 en 8 ss/nc slope comp slope comp sw pwm ea rsense current sense 1.22v uvlo otp uvlo uvlo pmos driver leb
p2583 linear integrated circuit unisonic technologies co., ltd 4 of 6 www.unisonic.com.tw qw-r103-052.b ? absolute maximum rating (note 2) parameter symbol ratings unit supply voltage v in 28 v switch voltage v sw -1~ v in +1 v feedback voltage v fb -0.3~6 v enable/uvlo voltage v en -0.3~6 v comp voltage v comp -0.3~6 v sync voltage v sync -0.3~6 v junction temperature t j 150 c storage temperature t stg -65~+150 c note:1. absolute maximum ratings are those values beyond which the device could be permanently damaged. absolute maximum ratings are stress ratings only and functional device oper ation is not implied. 2. exceeding these ratings may damage the device. ? recommended operating conditions (note 3) parameter symbol ratings unit input voltage v in 3.6~28 v ambient operating temperature t a -40 ~ +125 c note: 3. the device is not guaranteed to function outside its operating rating. ? package thermal characteristics (note 4) parameter symbol ratings unit junction to ambient ja 105 c/w junction to case jc 50 c/w note: 4. measured on approximately 1? square of 1 oz. copper surrounding device leads. ? electrical characteristics (unless otherwise specified v in =12v, t a =25c) parameter symbol test conditions min typ max unit feedback voltage v fb 4.75v v in 25v, v comp < 2v 1.198 1.222 1.246 v switch on resistance r sw 0.11 ? upper switch leakage i o(off) v en =0v, v sw =0v 0 15 a current limit i limit 3.3 a current limit gain. output current to comp pin voltage 5.5 a/v error amplifier transconductance i c =10 a 500 800 1100 a/v oscillator frequency f 342 380 418 kh z short circuit frequency f v fb =0v 25 50 75 kh z maximum duty cycle d max v fb =1.0v 90 % minimum duty cycle d min v fb =1.5v 0 % enable threshold v en i cc > 100 a 1.2 v enable pull up current i en v en =0v 1.5 a supply current (quiescent) i cc v en 2.6v; v fb =1.4v 2.2 3.5 ma shutdown current i sd v en =0v 20 35 a thermal shutdown t 160 c
p2583 linear integrated circuit unisonic technologies co., ltd 5 of 6 www.unisonic.com.tw qw-r103-052.b ? typical application circuit
p2583 linear integrated circuit unisonic technologies co., ltd 6 of 6 www.unisonic.com.tw qw-r103-052.b ? typical characteristics efficiency(%) utc assumes no responsibility for equipment failures that result from using products at values that exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or other parameters) listed in products specifications of any and all utc products described or contained herein. utc products are not designed for use in life support appliances, devices or systems where malfunction of these products can be reasonably expected to result in personal injury. reproduction in whole or in part is prohibited without the prior written consent of the copyright owner. the information presented in this document does not form part of any quotation or contract, is believed to be accurate and reliable and may be changed without notice.
|
