m/a-com division of amp incorporated n north america: tel. (800) 366-2266, fax (800) 618-8883 n asia/pacific: tel.+85 2 2111 8088, fax +85 2 2111 8087 n europe: tel. +44 (1344) 869 595, fax+44 (1344) 300 020 www.macom.com amp and connecting at a higher level are trademarks. specifications subject to change without notice. v2.00 ground plane size, resonant frequency and soldering notes for gps patch antennas 1307039 the choice of polarization indoor picocell antennas 1307039 application note unlike many outdoor environments, where direct line-of-sight between a transmitter and receiver allows reasonably unobstructed reception, indoor environments contain objects between the trans- mit and receive antennas. a linearly transmitted signal (either vertical or horizontal) can reflect off of walls and furniture, no longer traveling in a straight line. this multi-path effect causes signal degradation and even cancellation where there are many reflective surfaces inside a building. linear polarization tr reflective surface - angle of arrival multi-path vertical horizontal circular polarization circular polarization can significantly reduce multi-path effects in indoor environments. a circularly polarized signal is com- prised of two orthogonal (right-angle) linear signals separated 90 degrees in electrical phase. (the vertical and horizontally polar- ized signals are spatially 90 degrees apart, with a 90 degree time delay built into the antenna design.) time 90o vertical horizontal because different linear polarizations reflect and penetrate sur- faces differently depending on the angle of arrival and material type, the most effective way to reach inside buildings is to use a circularly polarized antenna. the circularly polarized wave, as shown above, contains all the senses of linear polarization, (where vertical and horizontally polarized signals have maxi- mum reflectivity off of a given surface at different angles), and will not cancel each other out. this allows for more continuous coverage in indoor environments than a purely linear polarized signal, and significantly increases the probability of maintaining the link. a combination of linear vertical polarization and circular polar- ization is also acceptable in designing indoor wireless networks, depending upon the materials making up the reflective surfaces. at 7 dbi and 7 dbic gain, our micropicocell antennas provide continuous and efficient coverage for any indoor system.
|
