specification part type/ frequency test ic vdd frequency stab. over aging over external number range mhz accuracy temp.range 10 years capacitance (pf) @25c (%) (-20 +80c)(%) (%) c1 & c2 zta mg 1.80 ~ 8.00 cd4069ube x 2 +5v 0.5 0.3 0.3 30 (over range) zta mt 8.00 ~ 13.00 cd4069ube x 2 +5v 0.5 0.3 0.3 30 (over range) zta mx 13.01 ~ 60. 00## 74hcu04 x 2 +5v 0.5 0.3 0.3 30 (13.01~20.0mhz ) 15 (20.01~25.99mhz) ##specification for frequencies from 50 to 60mhz may vary from above please enquire. 5 (26.00~60.00mhz ## ) vibration mode: mg thickness shear , mt thickness expander, mx thickness expander ( third overtone) type no. freq. (mhz) h w d p l a b zta mg 1.79 ~ 8.00 7.5 10 5 5.00.3 5.00.1 0.50.1 0.30.1 zta mt 8.00 ~ 13.00 10 10 5 5.00.3 5.00.1 0.50.1 0.30.1 zta mx 13.01 ~ 23.99 10 10 5 5.00.3 5.00.1 0.50.1 0.30.1 24.00 ~ 31.99 7.5 10 5 5.00.3 5.00.1 0.50.1 0.30.1 32.00 ~ 60.00 6.5 10 5 5.00.3 5.00.1 0.50.1 0.30.1 act zta through hole resonators dimensions mm (max) the act zta family of ceramic through hole resonators offers a cost effective solution for applications requiring a wide temperature range, together with accuracy. please note that all parameters can not necessarily be specified in the same device customer to specify : frequency, package type and size http://www.actcrystals.com in line with our ongoing policy of product evolvement and improvement, the above specification may be subject to change without notice iso9001:2000 registered for quotations or further information please contact us at: 3 the business centre, molly millars lane, wokingham, berkshire, rg41 2ey, uk tel : 0044 (0)118 979 1238 fax : 0044 (0)118 979 1283 email : info@actcrystals.com issue : 7 c1r date : 07-03-2008 important note when using ceramic resonators with microcontrollers some resonator parameters vary considerably with frequency and physical construction/size. these differences are too great to be able to be practically shown in a data sheet. however, these parameters can be critical when the resonators are used withmicrocontrollers. even if two different resonators appear to have the same specification the typical values of these critical parameters can be considerably different. when enquiring about resonators for use with imicricontrollers it is important to supply the make and part number of the ic to be used and/or the list of recommended resonators, if this is given.
|
