usv 1 tape packing specifications for 5-pin ultra super-mini (usv) package scope this specification provides the packaging requirements for 5-pin ultra super mini type transistors, fets, diodes, l-mos logics for use in automatic placement machines. 1. product naming system type of package for shipment is classified by a symbol suffixed to a product name. the method of classification is as below. (this method, however, does not apply to products of which electrical characteristics differ from the toshiba standard specifications.) [example] 2. tape dimensions 2.1 accumulated pitch tolerance is 0.2 mm/10 pitch. 2.2 the tape material is plastic. 2.3 the tape dimensions are per figure 1. unit: mm figure 1 ? toshiba is continually working to improve the quality and the reliability of its products. nevertheless, semiconductor devices in general can malfunction or fail due to their inherent electrical sensitivity and vulnerability to physical stress. it is the re sponsibility o f the buyer, when utilizing toshiba products, to observe standards of safety, and to avoid situations in which a malfunction or f ailur e of a toshiba product could cause loss of human life, bodily injury or damage to property. in developing your designs, pleas e ensure that toshiba products are used within specified operating ranges as set forth in the most recent products specifications . also, please keep in mind the precautions and conditions set forth in the toshiba semiconductor reliability handbook. ? the information contained herein is presented only as a guide for the applications of our products. no responsibility is assume d b y toshiba corporation for any infringements of intellectual property or other rights of the third parties which may result from i ts use. no license is granted by implication or otherwise under any intellectual property or other rights of toshiba corporation o r others. ? the information contained herein is subject to change without notice. 961001 eaa1 t c 7 s 0 0 f u ( t e 8 5 l ) indicates the specifications. indicates eiaj registration no. or toshiba?s house no.
usv 2 2.4 related matters 2.4.1 missing devices except for the leader and trailer portions of the tape there shall be no consecutive missing parts. the maximum number of missing parts cannot exceed 0.2% per reel. 2.4.2 electric characteristics electric characteristics of taping devices are shown in individual technical data. 3. reel 3.1 the reel dimensions are per figure 2. unit: mm figure 2 3.2 the reel material is plastic.
usv 3 4. packed system 4.1 packed parts quantity 3000 pcs per reel. 4.2 indication system [example] tc7s00fu (te85l) p/n: type tc7s00fu addc (te85l) q?ty 3,000 pcs note on special occasion add code, part no. etc. are often indicated in indicating label of the reel. 4.3 part orientation in the carrier tape shall be as shown in figure 3. figure 3 pin 1 exists on the left below of the marking. [example] top view l denotes te85l r denotes te85r 1 e 1 2 3 5 4
usv 4/e 5. the leader and trailer portion of the tape shall be as shown in figure 4 . figure 4 note1: the leader portion shall consist of a piece of cover tape minimum length of 300 mm and a piece of carrier tape with empty portion of 100 mm minimum. note2: the trailer portion shall consist of an empty carrier of more than 10 cavities.
|
