spec no: dsaa6462 rev no: v.3 date: mar/22/2005 page: 1 of 3 approved: j. lu checked: allen liu drawn: h.q.yuan l - 7113yd - 14v yellow description the yellow source color devices are made with gallium arsenide phosphide on gallium phosphide yellow light emitting diod e. package dimension s t - 1 3/4 (5mm) solid state lamp features z low power consumption. z popular t - 1 3/4 diameter package. z general purpose leads. z reliable and rugged. z long life - solid state reliability. z available on tape and reel. z 14v internal resistor. z rohs compliant. notes: 1. all dimensions are in millimeters (inches) . 2. tolerance is 0.25(0.01") unless otherwise noted . 3. lead spacing is measured where the leads emerge from the package. 4. specifications are subject to change without notice .
spec no: dsaa6462 rev no: v.3 date: mar/22/2005 page: 2 of 3 approved: j. lu checked: allen liu drawn: h.q.yuan selection guid e n ote: 1. 1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. part no. dice lens type iv (mcd) v=14v viewing angle min. typ. 2 1/2 l - 7113yd - 14v yellow (gaasp/gap) yellow diffused 5 16 30 electrical / optical characteristics at t a =25 c symbol parameter device typ. max. units test conditions peak peak wavelength yellow 590 nm v f =14v d dominant wavelength yellow 588 nm v f =14v ? 1/2 spectral line half - width yellow 35 nm v f =14v i f forward current yellow 10.5 13.5 ma v f =14v i r reverse current yellow 10 ua v r = 5v absolute maximum ratings at t a =25 c parameter yellow units power dissipation 160 mw forward voltage 16 v reverse voltage 5 v operating temperature - 40c to +70c lead solder temperature[1] 260c for 3 seconds storage temperature - 40c to +85c lead solder temperature[2] 260c for 5 seconds notes : 1.2mm below package base. 2.5mm below package base.
spec no: dsaa6462 rev no: v.3 date: mar/22/2005 page: 3 of 3 approved: j. lu checked: allen liu drawn: h.q.yuan yellow l - 7113yd - 14v remarks: if special sorting is required (e.g. binning based on luminous intensity, or wavelength), the typical accuracy of the sorting process is as follows: 1. wavelength: +/ - 1nm 2. luminous intensity: +/ - 15% note: accuracy may depend on the sorting parameters.
|
