the microamp MB-16 circuit board is designed for rapid prototyping of tunable bandpass ?lters using hitte microwave devices in lp4e packages with rf inputs on pin 3, rf outputs on pin 16, and control connectons on pins 8-10. filter mmics are available at various frequencies throughout the 6.8 to 21 ghz range. this board will ?t the microamp mh series of connectorized housings that allow it to be used as a stand-alone multplier or cascaded with other microamp boards for added versatlity. boards are fabricated from a high-performance 13 mil thick ro-4350 laminate with rohs compatble enig platng (electroless nickel/immersion gold) on both the component side and the solid botom ground plane. the board measures 0.490" x 0.590" and mounts into the housing with four or eight #1-72 screws for optmal high frequency grounding. filter circuits can be easily assembled with standard surface-mount passive components. the MB-16 includes provisions for control bias bypassing. pads for the input/output rf connectors allow the sma center pins to be easily soldered to the board afer it is installed into the housing, as well as large pads to connect the control voltages to feed-throughs. check the speci?c data sheet for the ?lter being used. many of the pins are unused and need not be soldered to the ground plane. assembly tunable filter schematic for additional product information, plea s e visit www .twinind.com contact information: 925-866-8946 (phone) 925-866-8937 (fax) sales@twinind.com microamp MB-16 circuit board for hittite tunable filters in sp4e packages ref size function c1 0402 bias bypass (not labeled) c2 0402 bias bypass (not labeled) c3 0402 bias bypass (not labeled) u1 lp4e tunable filter j1 rf input (pin 3) j2 rf output (pin 16) j3 control bias (pin 8) j4 control bias (pins 9,10) ? fits hitte microwave tunable ?lters with lp4e packages ? usable with hmc895-898 tunable bandpass ?lters ? uses standard smd passive parts ? ro-4350 board material ? fits microamp mh-series housings features
|