extractor tool for 0.6mm (.02") cp crimp terminals doc no: ats-638132400 release date: 04-13-07 uncontrolled copy page 1 of 2 revision: c revision date: 02-28-12 extractor tool application tooling specification sheet order no. 63813-2400 features this extractor tool is for the removal of 98913 and 64322 series female terminals from cmc connector. scope products : 0.6mm (.02") cp crimp terminal for cmc connector. terminal series no. description housing series no. terminal order no. 64322 0.635mm (.025") cp female terminal 98835, 98993, 98994,and 98995 64322-1019 64322-1029 64322-1039 64322-1219 64322-1229 64322-1239 64322-1319 64322-1329 64322-1339 64322-1349 64322-1359 98913 0.635mm (.025") cp female terminal 98835, 98993, 98994,and 98995 98913-1019 98913-1029 98913-1039 98913-1219 98913-1229 98913-1239 98913-1319 98913-1329 98913-1339 98913-1349 98913-1359 98913-1419 98913-3019 98913-3029 98913-3039 operation: when removing a damaged crimped wire from the cmc c onnector follow the steps below: 1. the secondary lock on the cmc connector will need t o be opened first. see figure 1. 2. using a screwdriver insert the flat edge under the tab of the secondary lock and pull up. use your fi ngers to open the lock completely. secondary lock figure 1 screwdriver cmc connector wire
extractor tool for 0.6mm (.02") cp crimp terminals doc no: ats-638132400 release date: 04-13-07 uncontrolled copy page 2 of 2 revision: c revision date: 02-28-12 markings on back and front of housing orient blades into housing cavities push extractor tool into front face figure 2 crimped wire secondary lock open 3. position the blades of the extraction tool into the two small cavities of the slot in the front face o f the housing as shown in figure 2. use the identifying markings on both the front and back of the connector to loc ate the opening used to extract the crimped wire. 4. push extractor tool into the desired slot until it clicks or comes to a stop. do not force the extrac tor tool any further or there can be damage to the housing. 5. gently push the wire forward towards the housing an d then pull out of the cmc housing. 6. molex does not offer repair parts for extractor too ls due to the inexpensive nature of these tools. visit our web site at http://www.molex.com
|