1 155 mbps bi-directional sc receptacle single fiber transceiver b-1x/1x-155-f-ssc3ds-10 20550 nordhoff st. ? chatsworth, ca 91311 ? tel: 818.773.9044 ? fax: 818.576.9486 9f, no 81, shui lee rd. ? hsinchu, taiwan, r.o.c. ? tel: 886.3.5169222 ? fax: 886.3.5169213 luminentoic.com lumnds1952-sep2608 rev a.0 parameter symbol min typical max unit notes optical optical transmit power p o -14 - -8 dbm output power is coupled into a 9/125 m single mode ?ber output center wavelength 1260 1310 1360 nm b-13/15-155-f-ssc3ds-10 output center wavelength 1480 1530 1580 nm b-15/13-155-f-ssc3ds-10 output spectrum width ? - - 3 nm rms( ) extinction ratio er 8.2 - - db output eye compliant with itu recommendation g.957/stm-1 optical rise time t r - - 2 ns 10% to 90% values optical fall time t f - - 2 ns 10% to 90% values optical isolation 30 - - db tx: 1310nm / rx: 1550 nm relative intensity noise rin - - -116 db/hz total jitter tj - - 1.0 ns measured with 2 23 -1 prbs with 72 ones and 72 zeros. transmitter speci?cations features ? diplexer single mode single fiber 2x5 sff sc receptacle connector ? wavelength tx 1310nm/rx 1530 nm (b-13/15-155-f-ssc3ds-10) ? wavelength tx 1530nm/rx 1310 nm ( b-15/13-155-f-ssc3ds-10) ? sonet oc-3 sdh stm-1 compliant ? single +3.3v power supply ? lvpecl differential inputs and outputs ( b-1x/1x-155-f-ssc3 ds-10 ) ? wave solderable and aqueous washable ? class 1 laser int. safety standard iec-825 compliant ? uncooled laser diode with mqw structure ? complies with telcordia (bellcore) gr-468-core ? rohs compliance available parameter symbol min. max. unit note power supply voltage v cc 0 3.6 v input voltage - 0 vcc v output current i out - 30 ma soldering temperature - - 260 oc 10 seconds on leads only operating temperature t opr 0 70 oc storage temperature t stg -40 85 oc absolute maximum rating parameter symbol min. typ. max. unit power supply voltage v cc 3.1 3.3 3.5 v operating temperature t opr 0 - 70 oc data rate - - 155 - mbps recommended operating condition
2 155 mbps bi-directional sc receptacle single fiber transceiver b-1x/1x-155-f-ssc3ds-10 20550 nordhoff st. ? chatsworth, ca 91311 ? tel: 818.773.9044 ? fax: 818.576.9486 9f, no 81, shui lee rd. ? hsinchu, taiwan, r.o.c. ? tel: 886.3.5169222 ? fax: 886.3.5169213 luminentoic.com lumnds1952-sep2608 rev a.0 parameter symbol min typical max unit note electrical supply current i cc - - 100 ma the current excludes the output load current data output voltage-low v ol -v cc -2.0 - -1.58 v these outputs are compatible with 10k, 10kh and 100kecl and pecl outputs data output voltage-high v oh - v cc -1.1 - -0.74 v signal detect output voltage-low v sdl- v cc -2.0 - -1.58 v signal detect output voltage-high v sdh- v cc -1.1 - -0.74 v receiver speci?cations parameter symbol min typical max unit notes electrical supply current i cc - - 140 ma maximum current is speci?ed at vcc= maximum @ maximum temperature differential input voltage v ih -v il 300 - 2000 mv internally ac-coupled transmitter disable voltage v dis 2 - vcc v lvttl input, tx disable pin 8 tx enabled when open circuit transmitter enable voltage v en 0 - 0.8 v transmitter speci?cations parameter symbol min typical max unit notes optical sensitivity - - - -33 dbm measured with 2 23 -1 prbs,ber= 10 -10 maximum input power p in -3 - - dbm signal detect-asserted pa - - -33 dbm measured on transition: low to high (note 1) signal detect-deasserted pd -45 - - dbm measured on transition: high to low (note 1) signal detect-hysteresis - 1 - 4 db cross talk - - - -33 db wavelength of operation - 1480 - 1600 nm b-13/15-155-f-ssc3ds-10 wavelength of operation 1260 - 1360 nm b-15/13-155-f-ssc3ds-10 note 1: the sd level should be deasserted when ?ber disconnected receiver speci?cations
3 155 mbps bi-directional sc receptacle single fiber transceiver b-1x/1x-155-f-ssc3ds-10 20550 nordhoff st. ? chatsworth, ca 91311 ? tel: 818.773.9044 ? fax: 818.576.9486 9f, no 81, shui lee rd. ? hsinchu, taiwan, r.o.c. ? tel: 886.3.5169222 ? fax: 886.3.5169213 luminentoic.com lumnds1952-sep2608 rev a.0 pin symbol notes 1 rxgnd directly connect this pin to the receiver ground plane 2 rxvcc +3.3v dc power for the receiver section 3 sd active high on this indicates a received optical signal(lvpecl/lvttl) 4 rd- receiver data out bar(lvpecl) 5 rd+ receiver data out (lvpecl) 6 txvcc +3.3v dc power for the transmitter section 7 txgnd directly connect this pin to the tranmitter ground plane 8 txdis transmitter disable(lvttl) 9 td+ transmitter data in (lvpecl) 10 td- transmitter data in bar (lvpecl) connection diagram warnings
4 155 mbps bi-directional sc receptacle single fiber transceiver b-1x/1x-155-f-ssc3ds-10 20550 nordhoff st. ? chatsworth, ca 91311 ? tel: 818.773.9044 ? fax: 818.576.9486 9f, no 81, shui lee rd. ? hsinchu, taiwan, r.o.c. ? tel: 886.3.5169222 ? fax: 886.3.5169213 luminentoic.com lumnds1952-sep2608 rev a.0 recommended circuit schematic the split-loaded terminations for ecl signals need to be located at the input of devices r eceiving those ecl signals. the power supply ?ltering is required for good emi performance. use short tracks from the inductor l1/l2 to the module rx vcc. a gnd plane under the module is required for good emi and sensitivity performance. tx rx terminate at transceiver inputs z=50 ? z=50 ? 100 ? td- td+ 130 ? 82 ? vcc(+3.3v) 100 ? rd+ rd- sd z=50 ? z=50 ? z=50 ? 130 ? 130 ? vcc(+3.3v) vcc(+3.3v) phy device lvpecl lvpecl 10 ? f c3 c2 1 ? h 6 7 8 10 9 1 2 3 4 5 1 ? h c1 terminate at device inputs note:c1=c2=c3=100nf rxgnd rxvcc sd rd- rd+ txvcc txgnd td+ td- txdis vcc(+3.3v) 130 ? 130 ? lvttl tx disable lvpecl b-1x/1x-155-f-ssc3 ds-10
5 155 mbps bi-directional sc receptacle single fiber transceiver b-1x/1x-155-f-ssc3ds-10 20550 nordhoff st. ? chatsworth, ca 91311 ? tel: 818.773.9044 ? fax: 818.576.9486 9f, no 81, shui lee rd. ? hsinchu, taiwan, r.o.c. ? tel: 886.3.5169222 ? fax: 886.3.5169213 luminentoic.com lumnds1952-sep2608 rev a.0 recommended circuit board layout d i m e n s i o n i n m i l l i m e t e r ( i n c h e s ) n o t e s : 1 . t h i s f i g u r e d e s c r i b e t h e r e c o m m a n d c i r c u i t b o a r d l a y o u t f o r t h e s f f t r a n s c e i v e r . 2 . t h e h a t c h e d a r e a s a r e k e e p - o u t a r e a s r e s e r v e d f o r h o u s i n g s t a n d o f f . n o m e t a l t r a c e s o r g r o u n d c o n n e c t i o n i n k e e p - o u t a r e a s . 3 . t h e m o u n t i n g s t u d s s h o u l d b e s o l d e r e d t o c h a s s i s g r o u n d f o r m e c h a n i c a l i n t e g r i t y .
6 155 mbps bi-directional sc receptacle single fiber transceiver b-1x/1x-155-f-ssc3ds-10 20550 nordhoff st. ? chatsworth, ca 91311 ? tel: 818.773.9044 ? fax: 818.576.9486 9f, no 81, shui lee rd. ? hsinchu, taiwan, r.o.c. ? tel: 886.3.5169222 ? fax: 886.3.5169213 luminentoic.com lumnds1952-sep2608 rev a.0 pin 5 pin 1 stand-off housing lead pin 10 pin 6 stand-off matel finger housing lead stand-off stud package diagram b-1x/1x-155-f-ssc3d s-10
7 155 mbps bi-directional sc receptacle single fiber transceiver b-1x/1x-155-f-ssc3ds-10 20550 nordhoff st. ? chatsworth, ca 91311 ? tel: 818.773.9044 ? fax: 818.576.9486 9f, no 81, shui lee rd. ? hsinchu, taiwan, r.o.c. ? tel: 886.3.5169222 ? fax: 886.3.5169213 luminentoic.com lumnds1952-sep2608 rev a.0 ordering information b - 1x/1x - 155 - f - s sc 3 pack age shielding finger -10 -rohs ? wavelength 13/15: tx wavelength=1310nm rx wavelength=1530nm 15/13: tx wavelength=1530nm rx wavelength=1310nm ? communication protocol lvpecl sd output ? connector options ? +3.3 v sff transceiver ? single mode ?ber ? intermediate reach available options: y b-13/15-155-f-ssc3ds-10 b-15/13-155-f-ssc3ds-10 b-13/15-155-f-ssc3ds-10-g5 b-15/13-155-f-ssc3ds-10-g5 ? package option d = black case part numbering de?nition: ? shielding finger option s = with shielding ?nger ? ordering information blank = rohs non-compliant product g5 = rohs compliant ? -10: molding bosa, removing 100r termination.
8 155 mbps bi-directional sc receptacle single fiber transceiver b-1x/1x-155-f-ssc3ds-10 20550 nordhoff st. ? chatsworth, ca 91311 ? tel: 818.773.9044 ? fax: 818.576.9486 9f, no 81, shui lee rd. ? hsinchu, taiwan, r.o.c. ? tel: 886.3.5169222 ? fax: 886.3.5169213 luminentoic.com lumnds1952-sep2608 rev a.0 important notice! all information contained in this document is subject to change without notice, at luminentoic s sole and absolute discretion. luminentoic warrants performance of its products to current speci?cations only in accordance with the companys standard one-year warranty; however, speci?cations designated as preliminary are given to describe components only, and luminentoic expressly disclaims any and all warranties for said products, including express, implied, and statutory warran - ties, warranties of merchantability, ?tness for a particular purpose, and non-infringement of proprietary rights. please refer to the companys terms and conditions of sale for further warranty information. luminentoic assumes no liability for applications assistance, customer product design, software performance, or infringement of patents, services, or intellectual property described herein. no license, either express or implied, is granted under any patent right, copyright, or intellectual property right, and luminentoic makes no representations or warranties that the product(s) described herein are free from patent, copyright, or intellectual property rights. products described in this docu - ment are not intended for use in implantation or other life support applications where malfunction may result in injury or death to persons. luminentoic customers using or selling products for use in such applications do so at their own risk and agree to fully defend and indemnify luminentoic for any damages resulting from such use or sale. the information contained in this document is provided on an as is basis. customer agrees that luminentoic is not liable for any actual, consequential, exemplary, or other damages arising directly or indirectly from any use of the information contained in this document. customer must contact luminentoic to obtain the latest version of this publication to verify , before placing any order, that the information contained herein is current. ? luminentoic, inc. 2003 all rights reserved handling precautions: this device is susceptible to damage as a result of electrostatic discharge (esd). a static free environment is highly recommended. follow guidelines according to proper esd procedures. laser safety: radiation emitted by laser devices can be dangerous to human eyes. avoid eye exposure to direct or indirect radiation. warnings: legal notes:
|
