features: high performance ingaas pin photodiode wide operating temperature (-40c to 85c) 1260-1600 wavelength response pigtailed package data rates up to 6ghz analog bandwidth application catv analog receiver, satelite distribution networks, analog video 5 ghz 1310nm pin diode pigtailed package pin-1310-5i-xxx preliminary data sheet the pin-1310-5i-xxx is a high-performance ingaas pin photo-detector packaged to meet performance requirements of analog fiber applications. the to-46 component can is mounted inside an ultem coaxial package which is then pigtailed with a singlemode fiber and terminated with a fiber connector. the pigtail comes in a choice of 50cm or 100cm lengths as standard, terminated with either fc or sc connectors with an apc or upc polish. applications include catv and other analog network applications. part number description pin-1310-5i-50smf-fcupc 1310 nm pin diode, 50cm singlemode pigtailed package, fc upc connector. pin-1310-5i-50smf-fcapc 1310 nm pin diode, 50cm singlemode pigtailed package, fc apc connector. pin-1310-5i-50smf-scupc 1310 nm pin diode, 50cm singlemode pigtailed package, sc upc connector. pin-1310-5i-50smf-scapc 1310 nm pin diode, 50cm singlemode pigtailed package, sc apc connector. pin-1310-5i-100smf-fcupc 1310 nm pin diode, 100cm singlemode pigtailed package, fc upc connector. PIN-1310-5I-100SMF-FCAPC 1310 nm pin diode, 100cm singlemode pigtailed package, fc apc connector. pin-1310-5i-100smf-scupc 1310 nm pin diode, 100cm singlemode pigtailed package, sc upc connector. pin-1310-5i-100smf-scapc 1310 nm pin diode, 100cm singlemode pigtailed package, sc apc connector. other fiber lengths and connector options avaialble on request.
pin-1310-5i-xxx 5ghz 1310nm pin diode notice: stresses greater than those listed under ?absolute maximum ratings? may cause permanent damage to the device. this is a stress rating only and functional operation of the device at these or any other conditions above those indicated in the operations section for extended periods of time may affect reliability. notice: the inherent design of this component causes it to be sensitive to electrostatic discharge (esd). to prevent esd-induced damage and/or degradation to equipment, take normal esd precautions when handling this product. absolute maximum ratings parameter rating storage temperature -40 o c to +85 o c case operating temperature -40 o to +85 o c lead solder temperature 260 o c, 10 seconds pin reverse voltage 10v pin forward current 2ma incident optical power +6 dbm average, +10 dbm peak esd exposure level (human body model) 50v electrical-optical characteristics t a = 25 o c unless otherwise stated vcsel parameters test condition symbol min. typ. max. units notes responsivity 1310nm, vr=5v r 0.80 0.85 ma/mw 1 capacitance f=100khz c 0.2 0.35 0.45 pf 2 wavelength response resp 1260 1310 1600 nm 3 dark current v r = 5v i dark 5 na pin -3db bandwidth into 50 , -5v bias bw 6 7 ghz 4 rise/fall time p=0.1mw p-p t r / t f 50 100 ps 5 maximum fiber input power =1310nm p max 3 mw optical return loss orl 23 db notes 1. responsivity is for the entire pigtailed assembly, measured at 1310nm. 2. capacitance is measured at 5v reverse bias. the pin structure is fully depleted at less than 2v reverse bias. 3. photodiode may respond to wavelengths outside this range, but is not guaranteed to do so. 4. bandwidth is measured using small signal analysis. 5. the rise and fall times are measured using a laser source with transition times less than 30ps (20-80%), and an average powe r of 0.5mw.
pin-1310-5i-xxx 5ghz 1310nm pin diode pin header pinout number function 1 ground / pin cathode 2 pin anode 3 open 4 open mounting dimensions (for reference only): dimensions in millimeters note this drawing is for pin refernce only. the features shown are not present on the to46 pin diode header.
?2007 finisar corporation. all rights reserved. finisar is a regi stered trademark of finisar corporation. features and specific ations are subject to change without notice. 08/08 rev. b phone: 1-866-my-vcsel usa (toll free) 1-214-509-2700 usa (direct dial) 44 (0) 174 336 5533 europe 886-935-409898 china & taiwan 81-90-4437-1130 japan 82-11-220-6153 asia pacific & korea fax: 1-214-509-3709 usa email: salesaocd@finisar.com web: www.finisar.com/aoc.php advanced optical components finisar?s advanced optical components division was formed through strategic acquisition of key optical compon- ent suppliers. the company has led the industry in high volume vertical cavity surface emitting laser (vcsel) and associated detector technology since 1996. vcsels have become the primary laser source for optical data communi- cation, and are rapidly expanding into a wide variety of sensor applications. vcsels? superior reliability, low drive current, high coupled power, narrow and circularly symmetric beam and versatile packaging options (including arrays) are enabling solutions not possible with other optical technologies. advanced optical components is also a key supplier of fabrey-perot (fp) and distributed feedback (dfb) lasers, and optical isolators (oi) for use in single mode fiber data and telecommunications networks location allen, tx - business unit headquarters, vcsel wafer growth, wafer fabrication and to package assembly. fremont, ca ? wafer growth and fabrication of 1310 to 1550nm fp and dfb lasers. shanghai, prc ? optical passives assembly, including optical isolators and splitters. sales and service finisar?s advanced optical components division serves its customers through a worldwide network of sales offices and distributors. for application assistance, current specifications, pricing or name of the nearest authorized distributor, contact a nearby sales office or call the number listed below. aoc capabilities advanced optical components? advanced capabilities include: 1, 2, 4, 8, and 10gbps serial vcsel solutions 1, 2, 4, 8, and 10gbps serial sw detector solutions vcsel and detector arrays 1, 2, 4, 8, and 10gbps fp and dfb solutions at 1310 and 1550nm 1, 2, 4, 8, and 10gbps serial lw detector solutions optical isolators from 1260 to 1600nm range laser packaging in to46, to56, and optical subassemblies with sc, lc, and mu interfaces for communication networks vcsels operating at 670nm, 780nm, 980nm, and 1310nm in development sensor packages include surface mount, various plastics, chip on board, chipscale packages, etc. custom packaging options pin-1310-5i-xxx 5ghz 1310nm pin diode
|
