mitsumi data receiving module WMF-R07 features 1. light weight and thin type. 2. 5v supply voltage. 3. low current consumption 6ma (typ.). 4. transmission rate 1200 bps. 5. a set of mitsumi's transmitting module (afw- j23 model) is also available. 6. parts have been reduced to a large extent by using original ic. 7. applicable over a wide temperature range ( - 30~+80 c) with high sensitivity. telecommunication component specifications specifications item remarks min. typ. max. unit receiving frequency 309.680 309.700 309.720 mhz in case of * 1t = 500? min. 100 hz frequency response max. 600 condition * 1 will apply sensitivity -9 0 3 db image rejection 35 db pn9 measurement at 600bps. spurious response 35 db freq. drift vs. ambient temp. * a -20 0 +20 khz supply voltage 4.5 5.0 5.5 v current consumption 6 ma (special item) withstanding discharge 10 kv plus and minus electric discharges shall be performed ten times respectively after the rubber sheet has been placed on the steel plate and the hot pin has been inserted into the phonojack on the module (capacity : 200pf)
mitsumi data receiving module * a condition 20?5 ? * 1 assuming the receiver is given 30db at a deviation of 40khz dev having a s.s.g. deviating signal of t0, the cycle of the receiver shall meet the requirements, t1 < = t0 0.9 and t2 > = t0 1.1. t0 t0 s.s.g. modulating signal t1 t2 t2 t1 receiver output dimensions unit : mm general tolerance : 1 terminals 1. +b 2. data out 3. ground 4. ant 5. ant ground * for the technical details of the products in this page, please refer to sales promotion dept., tochigi mitsumi co., ltd. phone: 0283 (23) 3332.
|
