1 technical data sheet 75 ohm smc plug right angle connector clamp/solder attachment for rg180, rg195 confguration connector smc plug connector interface type rg180,rg195 cable attachment method (shield/contact) clamp/solder body style right angle electrical specifcations impedance, ohms 75 mechanical specifcations size length, in [mm] 0.725 [18.42] width/dia., in [mm] 0.345 [8.76] height, in [mm] 0.685 [17.4] . weight, lbs [g] 0.027 [12.25] connector type smc plug contact material and plating gold coupling nut material and plating brass, nickel hex size, in. 1 1/32 torque, in-lbs [nm] 5 [0.57] body material and plating brass, nickel dielectric type ptfe compliance certifcations (visit www.pasternack.com for current document) plotted and other data notes: v alues at 25 c, sea level 75 ohm smc plug right angle connector clamp/solder attachment for rg180, rg195 from pasternack enterprises has same day shipment for domestic and international orders. our rf, microwave and fber optic products maintain a 99% availability and are part of the broadest selection in the industry. click the following link (or enter part number in search on website) to obtain additional part information including price, inventory and certifcations: 75 ohm smc plug right angle connector clamp/solder attachment for rg180, rg195 PE4267 url: http://www.pasternack.com/smc-plug-standard-rg180-rg195-connector-PE4267-p.aspx PE4267 PE4267 rev 01 75 ohm smc plug right angle connector clamp/ solder attachment for rg180, rg195
? 2013 pasternack enterprises all rights reserved 2 PE4267 rev 01 scale n/a dwg title cad file 2233 fscm no. 53919 rev. - 042309 size a PE4267 notes: 1. unless otherwise specified all dimensions are nominal. 2. all specifications are subject to change without notice at any time. 3. dimensions are in inches [mm]. 4. fits mil-c-17 and equivalent cables. 1. slide clamp nut (1) over cable as shown in a. slide compression washer (2) over braid & seat against jacket. flair braid over compression washer (2). 2. slide braid clamp (3) over dielectric & under braid. push into washer until it stops. strip cable as shown in b. trim excess braid flush with surface of compression washer (2). insert cable assembly into body & tighten. solder center conductor in place. 3. insert ptfe (4) into connector. press down cap. assembly procedures 75 ohm smc plug right angle connector clamp/solder attachment for rg180, rg195 PE4267 cad drawing
|
